Haier HWR08XC3T User Manual page 25

Wall Installations: slide-out chassis only
Note: Remove the 1 or 2 shipping screws on the rear of the air conditioner
that hold the chassis to the outer shell casing. Once removed,
these do not have to be re-installed. To ensure that your air
conditioner is properly installed in the wall, it is recommended
that it be installed by a certified technician who is familiar with
through the wall installations.
1) Using wood, 1" or more in thickness, build a wooden frame to fit the
casing/cabinet dimensions of the unit which you have purchased.
2) Measure the outside width and the height of the frame to determine the
cutout dimensions necessary for the opening in the wall. The depth of the
frame will depend on the depth of the walL The finished frame must be set
in the inside wall. The frame has to be squared and leveled. Remember the
Frame has to be nailed securely to the wall studs. (See Fig. # 19)
wall
stud
_ _J[ t_ f ......
,--_-5_...._-._-_-=.-,..-_ -"_"'_ _._ . back-up
-- _i strip
'iI
/[
.... \, -
typical wood
framing
Fig. # 19
3) Now to install, insert the casing into the wall opening. (Remove the
chassis out first following steps 1 - 6 in Slide-out chassis section).
Make sure that the cabinet is at least 1/2" inch inside the room. Also the
side louvers should not be blocked. This is to have proper air circulation in
and around the compressor. (See Fig. # 20)
24