Troubleshooting Guide - Aficionado C883 User Manual

13.Troubleshooting Guide
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
Ice maker is unplugged Plug ice maker in.
Reset breaker - if it happens again, call an authorized service
Breaker tripped center.
Switch turned to "OFF" Turn switch to "ICE".
Level of ice has reached sensor tube - it is normal for ice maker to
Ice maker does not Storage bin is full, keeping ice be off.
operate maker off Ice maker in a room below 50°F(10°C) - room must be warmer for
ice maker to operate.
Drain pipe blocked
Clean the interior of drain pipe.
(Drain pump model)
Drain pump not operative Check the drain pump.
(Drain pump model) Call an authorized service center.
Ice cubes are too large Cube size control is set too cold Call an authorized service center.
Check water supply - filter may be restricted.
Not enough water
Ice cubes are too small Check inlet water valve - inlet screen may be restricted.
Cube size control set too warm Call an authorized service center.
Ice cubes are partially Spray jets may be partially
formed - ragged sides clogged Activate wash cycle (See page 19).
Storage bin should fill with ice
and ice maker should shut off in
Clean condenser.
12~16 hours -if not, condenser
Ice maker makes ice, may be dirty
but storage bin does Storage bin drain may be
not fill with ice Clean out drain, check installation.
partially restricted
Air flow to ice maker may be Check installation - kick plate/grill must be free of obstructions.
obstructed
Ice cubes are partially Check water supply - filter may be restricted.
formed - white at the Not enough water in reservoir Check inlet water valve - inlet screen may be restricted.
bottom Check for water leak in reservoir.
Check water supply - filter may be restricted.
Ice may be stuck in the
Check inlet water valve - inlet screen may be restricted or valve
evaporator and the unit is "frozen
up" does not operate.
Hot gas valve may not operate - check and repair or replace.
Too much heat load Inlet water valve leaks through, must be replaced.
Water pump does not operate, must be replaced or check for water
No water spray leak in reservoir.
Unit operates but no
ice falling into storage Fan motor does not operate or fan blade is broken, must be
bin No airflow replaced.
Condenser is completely blocked, must be cleaned.
Compressor does not operate Call an authorized service center.
properly or at all
Not enough refrigerant Call an authorized service center.
Hot gas valve leaks through Call an authorized service center.
21