Advertisement
TROUBLESHOOTING
=See appropriate
section in manual
unless directed
to a Husqvarna
Service
Centre.
PROBLEM
CAUSE
Poor cut-
1. Worn, bent or loose blade.
uneven
2. Wheel heights uneven.
3. Buildup of grass, leaves
and trash under mower.
Excessive
1. Worn, bent or loose blade.
vibration
2. Bent engine crankshaft.
Starter rope
hard to pull
Grass catcher
not filling
(if so equipped)
Hard to push
Loss of drive
or slowing
of
drive speed
.
.
3.
4.
Engine flywheel brake is on
when control bar is released.
Bent engine crankshaft.
Blade adapter broken.
Blade dragging in grass.
1. Cutting height too low.
2. Lift on blade worn off.
3. Catcher not venting air.
1. Grass is too high or wheel
height is too low.
2. Rear of lawn mower
housing or cutting blade
dragging in grass.
3. Grass catcher too full.
4. Handle height position not
right for you.
1. Belt wear.
2. Belt off of pulley.
3. Drive cable worn or broken.
4. "Loose" drive control system.
CORRECTION
1. Replace blade. Tighten
blade bolt.
2. Set all wheels at same
height.
3. Clean underside of
mower housing.
1. Replace blade. Tighten
blade bolt.
2. Contact a Husqvarna
or
other qualified service centre.
1. Depress control bar to
upper handle before
pulling starter rope.
2. Contact a Husqvarna
or
other qualified service centre.
3. Replace blade adapter.
4. Move lawn mower to cut
grass or to hard surface.
1. Raise cutting height.
2. Replace blade.
3. Clean grass catcher.
1. Raise cutting height.
2. Raise rear of lawn mower
housing one (1) setting
higher.
3. Empty grass catcher.
4. Adjust handle height to suit.
1. Check/replace
drive belt.
2. Check/reinstall
drive belt.
3. Replace drive cable.
4. Adjust drive control.
19
Advertisement
