Goldstar MV1604ST Installation Instructions Manual page 11

STEP 3: Prepare The Venting Blower
WALL-VENTED INSTALLATION:
1. Remove one blower unit mounting screw and one or
several blower plate mounting screw(s). Remove the
blower plate from cabinet. See Figure 14.
2. Carefully lift the blower unit out of the microwave oven.
3. Use side cutters or tin snips to cut and remove knockouts
B from Back plate. Discard knockouts. Be careful not to
distort the plate. See Figure 15.
4. Reassemble the blower wire. See Figure 16.
5. Rotate the blower unit so that the exhaust ports face the
rear of the cabinet. See Figure 17.
6. Place blower unit back into cabinet. Check that the exhaust
ports face towards the rear of the cabinet. Be sure the
wires are not pinched. See Figure 18.
7. Reattach the blower plate to cabinet so the exhaust ports
and blower plate opening are aligned. Attach with one
blower unit mounting screw and then one or several blower
plate mounting screw(s). See Figure 19.
Parts B
Plate
Parts
Blower Unit
'_ Mounting Screw
Figure 14
Knockouts Parts B
Figure 15
Figure 16
t
Unit
ExhaustPorts
Figure 17
Blower Plate
............. i Mounting Screw
Blower Unit
Back Plate
Exhaust
Ports
Figure 18
Blower Unit
Exhaust Ports
'_Blower Plate
MountingScrew
Figure 19
-11 -