Goldstar R1203H Owner's Manual page 5

OPERATING
• WARNING
To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY
INSTRUCTIONS before operating this appliance.
• CAUTION
When the air conditioner has been performing its cooling operation and is turned off or set to the fan
position, wait at least 3 minutes before resetting to the cooling operation again.
FUNCTION
O
Warmer Cooler _ _
BEFORE RESTARTING
Thermostat
WAIT THREE MINUTES
Operation
• THERMOSTAT
Turn the thermostat control to the desired setting.
The centrol position is a normal setting for average
conditions. You can change this setting, if neces-
sary, in accordance with your temperature prefer-
ence.
The thermostat automatically controls cooling or
heating, but the fan runs continuously whenever
the air conditioner is in operation. If the room is too
warm, turn the thermostat control clockwise. If the
room is too cool, turn the themostat control anti-
clockwise.
• OPERATION
O(OFF) :Turns
LOW FAN ( e ):
LOW COOL ( _ ) :
HIGH COOL (_):
LOW HEAT ( -_ ):
HIGH HEAT (-}_):
the air conditioner off.
Permits the low fan speed opera-
tion without cooling (heating).
Permits cooling with the low fan
speed operation.
Permits cooling with the high fan
speed operation.
Permits heating with the low fan
speed operation.
Permits heating with the high fan
speed operation.
A slight heat odor may come from the unit when first switching to HEAT after the cooling season is
over. This odor, caused by fine dust particles on the heater, will disappear quickly.