Window Requirements - Goldstar R7003 Owner's Manual

WindowRequirements
NOTE: All supporting parts should be secur_ to firm wood, masonry, or metal.
1. This unit is designed for installation in standard double hung windows with actual opening widths of
22" to 36" The upper and lower sash must open sufficiently to allow a clear vertical opening of 14"
from the bottom of the sash to the window stool.
2.If storm window presents interference, fasten a 2" wide wood strip (OUTER SILL) to inner window
sill across the full width d the sill. The wood strip should be thick enough to raise the height of the
window sill so that the unit can be installed without interference by the storm window frame.
See Fig. 5-2. Top of: wood strip should be approximately 3/4" higher than the storm window frame
(STORM WINDOW FRAME) or wood strip (OUTDOORS) to help _ndensation to drain properly to
the outside.
3. Install a second wood strip (approximately 6" long by 1-1/2" wide and same thickness as first strip)
in the center of the outer sill flush against the back off the inner sill. This will raise the L bracket as
shown Fig. 5-2
4. if the distance beh,¢een STORM WINDOW FRAME and WOOD STRIP MOUNTED ON TOP OF
INNER SILL is more than 1'_,two of wood strip are not necessary
iNNER WOOD STRIP MOUNTED 1" MAX.
Fig. _1 Fig. _2
HARDWARE ]
TYPE A: 1lEA TYPE B: 4EA TYPE C: 3EA
..... (SHORT SCREW) . (W_D SCREW) . (L BACKET)
TYPE D: 1EA TYPE E: 1EA TYPE F: 2EA
(SEAL STRIP) (SASH SEAL) (GUIDE PANEL)
(Adhesive backed) (Notadhesivebacked)