Hotpoint HTS22GBMARCC Owner's Manual & Installation Instructions page 18

Installation instructions
INSTALLING THE WATER LINE
(CONT.)
[] CONNECT THE TUBING TO THE
REFRIGERATOR (CONT.)
Insert the end of the tubing into the water valve
connection as far as possible. While holding the
tubing, tighten the fitting.
For plastic tubing flom a GE SmartGonnect
TM
Refligerator Tubing kit, insert the molded end
of the tubing into the refrigerator connection and
tighten compression nut until it is hand tight, then
tighten one additional mrn with a wrench.
Overfightening may cause leaks.
Fasten the tubing into the clamp provided to hold
it in a vertical position. You may need to pry open
the clamp.
TubingClamp
1/4" Compressions.,
Nut
Ferrule
(sleeve)
Refrigerator
Connection
I_ TURN THE WATER ON AT THE
SHUTOFF VALVE
Tighten any connections that leak.
Reatmch the access coveL
I_ PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate
against the back of the refligerator or against the
wall. Push the refligerator back to the wall.
START THE ICEMAKER
Set the icemaker power switch to the I (0n} position.
The icemaker will not begin to operate until it
reaches its operating temperature of 15°F (-9°C) or
below. It will then begin operation automatically if
the icemaker power switch is in the I (on} position.
NOTE: In lower water pressure conditions, the
water valve may ttlin on up to 3 times to deliver
enough water to the icemakeL
18