GE RA520W6 Owner's Manual page 9

Using theovenforbroiling.
Broiling may be slightly different from any previous broiling you may be acquainted with, so be sure to read this
section completely,
VERYIMPORTANTNOTE:
To reset the oven for Baking you
must turn the OVEN TEMP knob to
OFF.This gets it out of the BROIL
mode.
How to Set Your Oven for Broiling
Broiling is cooking food by intense radiant heat []
from the upper dement in the oven.Most fish
and tender cuts of meat can be broiled Follow
these steps to keep spattering and smoking to []
a minimum.
[]
Ifthe meat has tht or gristle around
the edge, cut vertical slashes through
both about 2" apart.
If desired, fat
may be trimmed, leax4ng layer about
l/S thick.
[]
Place the meat on the broiler grid in
the broiler pan whi(h comes with
y(nn range. Alwws use the grid so
the fltt drips into the broiler pan;
otherwise the juices m W become hot
enough m catch fire.
[]
[]
Close the door. Always broil with the
door dosed.
Turn tlle OVENTEMP knol)
clockxdse to BROIL You xdll feel
a slight niche at tlle broil position.
You may then turn the knob
counterclockwise to broil at a
lower temperature.
Turn food only once during
cooking.
Turn the OVENTEMP knob to OFF.
Serve fl)od immediately, and leave
the pan outside the oven to cool
during the meal for easiest cleaning.
[] Place tile shelf in position C for most
broiling.
U
_" >'_. ",, t, \'<
;7
Use of Aluminum Foil
• You can use ahnninum ti)il/o line your
broiler pan and broiler grid. However,
y_)u nmst mold the fl)il tightly to the
grid and cut sli/s in it just like the grid.
Without the slits, the fl)il will prevent
tat and meat juices flom draining to the
broiler pan. The juices could become
hot enough to cawh on fire. If you do
not (ut the slits, you are flying, not
broiling.
• DONOT place a sheet of ahmfinum fl)il
on the shelf. To do so may resuh in
improperly cooked fl)ods, damage to
oven finish and increase in heat on
()utside SUltitces of the ()yen.
• If desired, a sheet of ahnninum tbil may
be used on floor of the oven under the
bake element. Be certain foil doesnot
touchbake element. Ahnninum fi)il
used in this way may slightly aflbct the
bro_I_ing of some fl)ods. ( hange fl)il
when it becomes soiled.