Table of Contents
Advertisement
(_TV
POWER Button
®
HOW TO USE THE REMOTE TO CONTROL
YOUR TV
Press this button to tum the TV set on or off. If ON/OFF TIMER is set, it will be displayed when the TV is first
tumed on. (See page 42.)
SLEEP Button
Press this button to display the SLEEP TIMER in the lower left comer of the screen. Every subsequent press of
this button will add 15 minutes to the timer, up to a maximum of three hours.
MENU, CURSOR Buttons
All On-Screen Display features can be set or adjusted by using these buttons.
The MENU button will start the On-Screen Display.
®
The CURSOR buttons will highlight functions or adjust and set different features. Pressing the cursor buttons will
also give you access to the FAMILY FAVORITES CHANNELS On-Screen Display.
CHANNEL SELECTOR Buttons
Enter two or three numbers to select channels. Enter 0 first for channels 1 to 9. For channels 100 and above,
press the "1" button and wait for two seconds before pressing the last two digits of the channel.
Channel selection may also be performed by pressing CH up (A) or down (V).
You may also use these buttons for channel scanning. Press and hold the CH up (A) or down (V) buttons and
the TV will start quickly scanning through the channels. Release the CH up (A) or down (V) buttons when the
TV scans to the channel you wish to watch and the TV will tune to that channel.
I NOTE:
The TV may not receive somechannelsif you are not in the correctSIGNAL SOURCE mode. (See
page 35.)
(_) INPUT Button
The INPUT button will select between the antenna signal and the video input jacks each time the button is
pressed. If the Picture-in-Picture (P-in-P) is on, the INPUT will not select any source signal on the main picture.
However, if the P-in-P is on, the INPUT will aitemate between the main signal source and the input source on the
sub-picture. (See picture below and page 25.)
t
INPUT
INPUT
INPUT
I
_IDEO:I
(S-|N)
I
INPUT
VIDEO:2
22
Advertisement
Table of Contents
