Hitachi 61SBX59B Operating Manual page 32

USING THE REMOTE TO
CONTROL AUDIO EQUIPMENT FUNCTIONS
Operating the precoded function for your audio equipment.
This remote is designed to operate certain types of audio equipment. You must first program the remote to match the remote system
of your audio equipment. (Refer to page 33.)
1, Set the MULTI-PAGE select switch to AUDIO,
2. Turn ON the audio component you wish to control with your remote control (AMP, CD, or TAPE).
3. Aim the remote control at the front of your audio equipment.
4,
5. The remote will now control your audio component.
6. Repeat steps 2-5 until all audio equipment preset codes are
programmed into the remote.
Hold down the button on the remote which corresponds with the component you wish to control (AMP, CD, or TAPE). enter the two
digit preset code that matches your audio component as shown on page 33. The remote will turn off your audio component when
the correct two digit preset code is entered. When this occurs, the remote control is programmed for your audio component. If the
audio component does not turn off after five seconds, try a different two digit preset code.
NOTES:
1, If your audio equipment cannot be operated after
performing the above procedures, your audio component
code has not been precoded into the remote,
2. In the unlikely event that your audio component cannot be
operated after performing the above procedures, please
consult your audio components operating guide.
3. The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control. After replacing the batteries repeat the
entire programming procedure as stated above.
4. if your audio component does not have a power function,
the remote will issue another obvious function that the
audio component will respond to, such as CD open/close.
5. The default for AUDIO mode is AMR
If you wish to control your receiver or miscellaneous audio
equipment, you must follow the remote programming
procedure shown above. You may use only the AMP
button to program these codes, but note that this button
may not be used for more than one component.
6,
7. The LST-CH button will act as your audio component s
ENTER button if required,
8. The SLEEP button will act as your audio components
100 button if required.
(_ PRECODED AMP, CD, or TAPE buttons
These buttons transmit the chosen precoded audio
component codes,
EXCLUSIVE TV buttons
These buttons are for operating the TV.
TV/CABLE/SAT
VCR O
INFO Q
Q GUIDE
iiiiiiiiOHiiiiii
HIT_HI
CLU-615MP
32