Surface And Oven Lights (Some Models); Adjusting Oven Temperature - Gibson GEF357CBSB Owner's Manual

Surface and Oven
Lights
(some models)
_Be sure the range is
unplugged and all parts are COOL
before replacing the fluorescent or
oven lights.
Changing the Fluorescent Light (some models)
A switch on the control panel turns the cooktop light on and off. To replace,
follow these instructions:
1, Turn power off at the main source or unplug the range.
2. Grasp the front edge of the canopy cover as illustrated in the side column.
Pull forward and lift the cover up and off toward rear of range,
3. Remove bulb by rolling up and out. Install the new bulb by sliding down
into place and rolling toward front of range.
4, Align front edge of light cover with inside lip of end cap. Lower rear of
cover into place and snap down,
5. Turn power back on at the main source (or plug range back in),
Oven Light (some models)
The oven light automatically turns on when the door is opened and
automatically turns off when the door is closed (some models), Use the switch
(some models) located on the control panel to turn the light on when the door is
closed.
Changing the Oven Light
The oven Iight is located at the rear of the oven. To replace, follow these
instructions:
t, Turn electrical power off at the main source or unplug the range. BESURE
ALL OVEN PARTSARE COOL BEFORE REMOVING BULB,
2. Wear a leather-faced glove for protection against possible broken glass,
3. Presswire holder to one side to release the glass shield.
4. Replace bulb with a new 40 watt appliance bulb.
5. Replace glass shield in socket and snap wire holder into place,
6. Turn power back on again at the main source (or plug the range back in),
7. The clock (if equipped) will then need to be reset, Follow instructions under
Setting the Clock and Minute Timer.
Adjusting Oven
Temperature
Figure 1: Back of Control Knob
Note position of pointer
to marks before adjustment
The temperature in the oven has been set at the factory, When first using the
oven, be sure to follow recipe times and temperatures, If you think the oven is
too hot or too cool, the thermostat can be adjusted. Before adjusting the knob,
test a recipe by using a temperature setting higher or lower than the
recommended temperature, The baking results should help you to decide how
much of an adjustment is needed, The knob can be adjusted in increments as
indicated on the back of the knob.
To Adjust the Oven Temperature:
1. Check to be sure the Temperature knob is in the OFF position,
2. Pull the knob straight off the shaft,
3. Loosen the two screws at the back of the knob (Figure 1), There is a series
of small indicator lines directly opposite the OFF position, One of these
indicator lines is positioned next to a tiny pointer, Note the position of the
pointer, Note: If knob does not have 2 screws, it is not adjustable.
4. Adjust the temperature accordingly. To increase or decrease the
temperature, move the pointer in the direction of "H" to raise or "L" to
lower the temperature.
5. When the desired adjustment is reached, tighten both screws,
6. To replace the knob, line up the flat sides of both the knob and the shaft.
Push the knob into place. DO NOT force the Temperature knob onto the
shaft or you may damage the back of the knob.
Note: Once an adjustment is made, the OFF position will vary from the
reference mark on the backguard depending on the amount of adjustment,
14