Advertisement
A Monthly:
Door springs and door hardware:
Oil door roller, bearings, and hinges using silicone
lubricant or light oil
DO not operatedooiautomaticai[y
or manually if springs
[
are broken. Contact a Genie Factory Authorized Deater for
service orcaH Customer Service at 1.800.35.6ENIE.
1
,
BaHanceDoor.
-
CHosedoor.
-
ReleaseCarriage Assembly from Rail Assembly by pulling
the Emergency Release Knob towards the door.
-
Raise door manually 3L 4' and verify' that door stays at
that position. See Check Step 2 on page 4.
When the door is 3' _4' above the ground, the door
should stay open.
Slight movement is acceptable, ff
the door moves too much, contact a Genie Factory
Authorized Dealer for service or call Customer Service at
1-800=35-GENIE.
-
Reattach CarnageAssemb[y
to Rail Assembly:
a. Pull the Emergency Release Knob toward Power Head.
b. CHosedoor.
Contact Reverse Test.
-
Perform Adjustment 2 on page 8.
WARNING:
If the door fails to reverse on contact with the board
adjust the Close Force Control as specified in Set Limit
Switches and Force Controls on page 7 & 8. If the Opener
still fails, contact a Genie Factory Authorized Dealer for
service or call Customer Service at 1-800-35-GENIE
B Yearly:
Wipe off oid excess Hubdcant from Drive Screw.
Lubricate Drive Screw with Genie Lubricant GLU-3_
UseONLYGenie Lubricant (6LU-3). Other lubricants
may damage the Opener.
GLU-3
Lubricant
FCC AND [C CERTIFIED
this device must accept any interference received, indud
ins interference that may cause undesired operation.
C As needed
Replace lightbulbs.(See page 9)
Safe-T-Beam
® System
Self-Diagnostic
Troubleshooting
Source {Red LED)
Sensor {Green LED}
Possible
Problem
solution
ON
ON
Normal operation
None required
• Power Head not powered
o Check breakers, fuses, plugs
OFF
OFF
• Wiring from Power Head bad
• Check wiring for obvious
shorts
OFF
ON
• Wiring to Source missing or bad
• Check wiring
• Power has been interrupted
o Remove power and reappiy
2 BLINKS, Pause
o Beam not aligned
o Check Source, Sensor alignment
(Repeat)
ON
o Beam obstructed
o Check for obstruction
o Sensor defective
o Contact Customer Service
2 BLINKS, Pause
o Wire to Sensor missing or bad
o Check wiring
(Repeat)
OFF
o Sensor defective
o Contact Customer Service
-3 BLINKS, Pause
• Sensor receiving
interference
• Determine
source of interference
(Repeat)
ON
o Check for interference
from sun-
light or a source unit on an
adjacent door
• Contact Customer Service
4 BLINKS, Pause
o Source not sending pubes
o Contact Customer
Service
ON
(Repeat)
• Source defective
• Contact Customer
Service
1 0
For Help, call 1-800-35-GENIE
or visit www, geniecompanyocom
Hide quick links:
Advertisement
