GE Monogram ZMC1095 Series Use And Care Manual page 33

QUESTIONS. 9
USE THIS PROBLEM SOLVER
PROBLEM
OVEN W1LL NOT
COME ON
CONTROL PANEL
LIGHTED, YET OVEN
WILL NOT START
"'PROBE" APPEARS
ON DISPLAY
"'EITor" APPEARS
ON DISPLAY
"'HOT" APPEARS
ON DISPLAY
POSSIBLE CAUSE
• A fuse m your home may be blown or the mrcuit breaker rapped. Replace fuse or
reset circuit breaker.
• Set the clrcmt breaker to the offposmon. Walt 30 seconds. Reset the mrcmt breaker
to the on position.
• Door not securely closed.
• START pad must be touched after entenng cooking selecnon
• Another selecnon entered already m oven and CLEAR/OFF pad not touched
to cancel it.
• Make sine you have entered cooking rune or temperature after touching
MICRO COOK or TEMP COOK/HOLD pads
• CLEAR/OFF pad _,as touched accidentally. Reset cookmg program and touch
START pad.
• Temperature probe not inserted properly or not being used donng Combination
Roast or Temp Cook Hold.
• Make sure you have entered a desired finished tbod temperature or oven temperature
after settmg temperature coohng programs.
• Make sure you have entered a code number after touching SENSOR COOK
• Temperature probe is missing or not plugged m securely when using cookmg
funcnons that measure food temperature
• Temperature probe is inserted for a program that does not use the probe
• During Sensor Cook. Sensor Reheat, Sensor Beverage or Sensor Popcorn program,
the door was opened before steam could be detected, or steam was not detected m
maxunum time,
• This is nonnal \vhen the temperature msMe the oven is greater than 200 degrees
and the door is opened
• One of the sensor cooking pads was touched when the temperature reside the oven
was greater than 200 de_ees These features will not operate when the oven is hot.
All these things are normal with your microwave oven:
• Dunlnlng o\ en hght and change in blower sound
may occur while operating at power le\ els other
than high.
• Dull, thumping sound while oven is operating
• Solne TV-Radlo interference might be notlced while
using your microwave oxen It's smular to the
interference caused by other small apphances and
does not indicate a probleln with your o\ en.
• Stealn or vapor escaping ffoln around the door.
• Light reflection around door
• Dtmng cooking yon will hear "'cracking'" and
"'popping'" nmses which are nothlng more than
normal expansion of the oven
• At the end ofmlcrnwave cycles you will hear a
shght thulnp This is normal
lf_ou need more help...call, toll free: GE Ans¢,er Center" / 800.626.2000 / consumer information service
33