GE Spacemaker WSM2480 Use And Care Manual page 20

QUESTIONS?
USE THIS PROBLEM SOLVER
PROBLEM
WASHER OR DRYER
WON'T START
WON'T DRAIN
WATER LEAKS
WASHER WON'T
SPIN AND
COMPLETE CYCLE
CLOTHES ARE
ABNORMALLY
WET AFTER SPIN-
APPLIANCE IS
NOISY
WATER DOES NOT
ENTER OR ENTERS
SLOWLY
WATER
TEMPERATURE
INCORRECT
WASHER PAUSES
IN CYCLE
POSSIBLE CAUSE
• Make sure controls are properly set and washer cycle selector is pulled out or drver
START button is pushed.
• Appliance unplugged. Make sure cord is firmly plugged into electrical outlet.
• No power to appliance. Check fuses and circuit breakers to make sure appliance is
getting current.
• Dryer door is open. Dryer will not run with door open. Make sure washer lid is closed.
Washer will fill but will not spin with lid open.
• Make sure both hot and cold faucets are turned on.
• Kinked or pinched hose. Check and correct.
• Top of drain outlet should be less than 6 feet above the floor.
• Make sure hose connections are tight at faucets.
• Make sure end of drain hose is correctly inserted into and secured to drain facility.
• Lid not closed. Washer will not progress through spin cycle with lid up. Make sure
lid is closed.
• Load mav have been excessively out of balance. Redistribute clothes and rerun through
final spin.
• Heavily unbalanced loads can cause the washer to vibrate excessively dunng spin, and
may cause it to move from its original position. To correct, open the lid and redistribute
the load evenly about the wash basket. Close the lid and restart.
• Metallic "clicks" heard as timer advances during operation are normal.
• Uneven floor. Make sure appliance is level and finn to floor.
• Faucets turned off: Make sure faucets are on and adjusted correctly.
• Hoses kinked. Check and correct_
• Clogged screen in water valve. Unscrew fill hose from washer and clean screen if
necessary. When reassembling, make hand tight plus 1/3 turn with pliers.
• Faucets not adjusted to give desired temperature. Readjust them.
• Household water heater not set to deliver correct temperature--140 ° to 150°F.
! 60 ° to 66°C. / Reset it.
• Water valve screens may be clogged. Remove inlet hoses from water valve. Clean
the screens and reinstall the hoses.
• Make sure selector controls are properly set.
• Make sure hoses are connected to correct faucets--hot to hot_ cold to cold.
• Washer nonnally pauses about 1/2 minute in progressing from one portion of its cycle
to the next_
• Alternate pauses m the agitation are normal in the delicate wash cycle. Agitation will
resume in 1-2 minutes.
• The brief pause in the final spin of each cycle is nonnal operation for this washer.
20