GE J2B918 Installation And Owner's Manual page 32

Care and cleaning of the range.
Bumerheads
Burner Caps and Heads
Before removing the burner caps and heads,
remember their size and locat/bn. Replace them in
the same location after c/eambg.
NOTE: Do not use steel wool or scouring powders to
clean the burner parts.
Burner caps
IJfl off when cool. _A'ash burner caps in hot,
soapy water and _inse with clean water: You
may, scorn" with a l)lastic scom_ing, l)ad to
renloxe burned-on food particles.
Burner Heads and Oval (Center) Burner
Head/Cap Assembly
The burner heads and the oval burner head/cap
assembly are removable. Simply lift them off the
range for cleaning.
For proper ignition, make sm'e the
small hole in the section that fits oxer the
electrode is kept open, A sewing needle
or wire twist-tie works well to unclog it.
The slits in the burner heads must be kept clean
at all times for an even, unhampered flame.
Theburnerheads are removable. Cl()(,ged or dirty bm'ner ports or
Simply lift themoff therangefor ,_, ,
cleaning ,
electrodes will ilo( allow the btlriler tO
operate properly:
Any spill on or arotmd an electrode must
be careflflly cleaned. Take care to not hit an
electrode with anything hard or it coukl be
damaged.
Clean the bm'ner heads routinely, especially
after bad spillove_, which couM clog the
openings. I Jfl off when cool.
To relnove bm'ned-on fi)od, soak the
bm'ner heads in a solution of mild liquid
detergent and hot water fi)r 20-30 minutes.
For
I/IOI'e SttlbboI'II
StJliIIS_use a toothbrush.
Hulein
[_2 burner
The oval burner head/cap assembly is
removable. Simply !ift it off the range
for cleaning. Use a Sewing needle Or
twist-tie to unclog the small hole in
the burner heads.
After cleaning
Before putting the bm'ner caps, heads and
oval head/cap assembly back, shake out
excess water and then (li T them thoroughly
by setting in a waml ()veil for 30 Illilltl[eS.
Replacement
Burner Heads
Replace 1)urner heads over tile electrodes
on the cooktop, in tile correct locations
according to their size. There is one small,
olle llledit/lll, olle
large
alld olle extra
large
btlrller head.
M_ _ ';;!! I;i2-- Frent _ range -- _d'
Make sure tile slot in tile btu'ner head is
positi(med over the elecm _de.
Electrede_
Oval (Center) Burner Head/Cap Assembly
I_eplace tile ova] (center) head/cap
assembly over the electrode on the cooktop.
Oval head ana can
Vlake
sure me SlOt In tile
assernely 3urner neaa is 3OSl[ioneu
over tile elecffoae.
=rent ef range =lectrede
Caps
Replace the matching size caps onto the
bm'ner bases or hea&s.
Front of range
Make sm'e that tile heads and caps are
replaced in the correct locations.
32