GE DDE9200G Use And Care Manual page 5

O FabricCareSelections
Push a button to select theproper h eat f oryourload.
Fabric Care
Selections
Cottons
High Heat
Perm Press
Medium Heat
Knits/Delicates
Low Heat
Fluff
No Heat
Should be used with cycles
indicated •
Automatic
Regular Cycle
Automatic,
Peml Press and
Knits Cycles
Timed
C3cles
Extra Care Cycle
(Operates only with Automatic
Perm Press & Knits Cycle.)
Turn to ON if desired. To minimize
wrinkles set in the clothes, the Extra
Care cycle provides approximately
15 minutes of no-heat tumbling
after the clothes are dry.
Use End-of-Cycle Signal. Signal
will sound at five-minute intervals
to remind you to remove the clothes.
Select End of Cycle Signal, if
desired.
Turn Cycle Selector to desired
cycle setting. The selector may be
turned in either direction.
Press PUSH TO START button
to start dryer. (Opening the door
during operation stops the dryer. To
re-start, close the door and press
the START button,)
What is the difference
between Timed &
Automatic drying?
Timed Drying
When using the TIMED CYCLES,
you select the number of minutes
you wish the &yer to run and it
turns off at the end of this time
period.
Automatic Drying
When using the Automatic Cycles,
the Electronic Sensor Control
system continually senses the
moisture in the tumbling clothes,
determines when they are &led to
your pre-selected setting, and
terminates the cycle automatically.
Refer to the CONTROLS SETTING
GUIDE for recommended settings.
The Cycle Selector will not advance
until clothes have reached a certain
degree of dryness.
Dryness selections guide for
the automatic cycles
End-of-Cycle Signal
(Operates with any cycle.)
The Signal control can be set
anywhere between OFF and
LOUD, depending on desired
sound level. The signal will sound
just
before the end of the cycle to
remind you to remove the clothes.
To stop signal while sounding, turn
Signal control to OFF or advance
Cycle Selector to OFF.
The Signal should always be used
when &ying Polyester Knits or
Permanent Press items which
should be removed as soon as the
dryer stops to help prevent setting
of wrinkles.
The signal should also be used with
the Extra Care Cycle.
Polyester Knits &
Permanent Press
drying tips
• DO NOT OVERLOAD--
Garments being dried or
dewrinkled should tunable freely.
• REMOVE CLOTHES
PROMPTLY-To help prevent
wrinkling, remove from the dryer
promptly at the end of the drying
cycles.
• PLACE ON HANGERS--
Permanent Press and Polyester
Knit garments look best if placed
on hangers after dlTing.
Setto Middle Position
Cvcl_
• For most normal loads.
Set toward MORE DRY
_ S
• For loads that include heavy
weight fabrics.
• If you desire to remove more
moisture.
Set toward
LESS DRY
r@
• For lightweight fabric loads.
• If you desire to remove Iess
moisture.
• For very small loads.
V