GE DDE9200G Use And Care Manual page 11

PROBLEM POSSIBLE CAUSE AND REMEDY
SHRINKAGE,
KNITS
WRINKLING IN
PERMANENT PRESS
AND "NO-IRON"
ITEMS
• Relaxation shrinkage can occur in knit fabrics that have been improperly stretched
and elongated by tile manufacturer. When this occurs, garment maybe pressed back into
shape after each wash and dry cycle.
• Progressive or delayed shrinkage is caused when starch or sizing (in some fiabrics) is
gradually removed by laundering. Maybe noticed in older garments that have been
laundered many times without previous shrinkage• Treat as for Relaxation Shrinkage above•
• Shrinkage caused by overheating occurs in certain knit fhbrics that have been heat-
shaped• When washing, &Ting or ironing temperatures exceed the temperatures used to
shape set, shrinkage may occur. This cannot be corrected, but it call be prevented by
washing in cold or warm water; &ying on low heat•
• Leaving clothes in &yer after rambling stops• Remove clothes promptly and
hang
them immediately.
• Too many items in dryer. Dry only one washer load at a time. Do not combine loads•
• Too few items in dryer. If drying only one article, add two or more similar articles, even
if dry, to insure proper rambling.
• Improper loads• Avoid laundering heavy Permanent Press items, such as work clothes,
with lighter Pernlanent Press items, such as shirts or blouses• Do not wash or &Y
Permanent Press with regular laundry.
•Too many clothes in washer• Items must have room to move freely. Permanent Press
loads should always be smaller than regular loads•• .no more than medium loads•
• Use of incorrect wash and dry cycles. Use Permanent Press Wash Cycle which provides
a cool-down rinse to minimize wrinkling. Also, use Permanent Press DU Cycle.
• Incorrect water level. Use large water level for medium load; medium level or half full
for small load.
•Washing repeatedly in too hot water• Wash in cool or warm water with plenty of detergent•
(continued nextpage_