GE TBX22PRBMLBB Owner's Manual page 29

Connect the Tubing to the Refrigerator
Before making the connection to the refrigerator, be sure the
refrigerator
power cord is not
plugged
into the waft outlet.
_,te recommend installirig _ _ ater filter i[}our _ ater supply has sand or particles
I 1 )? that COil d c ( g the screen of the refl'igerator's water valve. ][nst}tllit ill the water
line near the refl'igerator.
Remove tile plastic flexible cap fl'om the water valve.
JPlace the compression nut and terrule (sleeve) onto tile end oithe tubing
}ic_as sh(mn.
_[nsert the end of the copper robing into the _ater valve connection as thr as
:::::_possible. While holding the tubing, tighten the fitting.
dl_asten the copper tubing into the clamp provided to hold it in a vertical
:::::::::::" position. YOUIll}t}need to pl), open the clamp.
1/4"CopperTubing Nbing Clamp\
Ferrule(sleeve)
Ret_igerator Connection
Turn the Water On at the Shutoff Valve
Tighten any conne(tions that leak.
Plug In the Refrigerator
Arrange the coil el
copper
tlfl)ing so th?lt it does not vii)rate ag_dnst the b_tck of
the refligerator or against the wall. Push the reh'igerator back to the wall.
Start the Icemaker
Set the i(emaker
teeler arm to the ON ((h)wn) position. Tile icemaker will
not begin to operate tmtil it reaches its operaung temperature of 15 F (-[_ C)
or below. It will then begin operation automatically if the icemaker teeler arm
ixin the Oh/(down) position.
NOTE." T heicem;)ker m<_y d ouble®de whenit firstst;)rts,c;Tusing s omewaterspillagetrom
the icemaker i ntothe icebucke£ Thisis normal a ndshouMnoth;Tppen a g;_in.
?
29 ......................................