GE WISQ416C Owner's Manual page 16

Problem
Possible Causes
What to Do
Not enough detergent
on a consistent basis
Always use the recommended amount of
detergent.
Chlorine bleach may yellow • Use non-chlorine bleach.
some fabrics
Iron or manganese in water may * Use extra detergent plus a non-precipitating
cause yellowing or yellow spots water softener dissolved in water and
non-chlorine bleach.
0
0
Run hot water for 2 mimltes to help the
pipes clean out iron buildup.
Drain your house water heater occasionally.
To remove spots spread stain area over a pan
of boiling water and squeeze lemon juice
through the stain.
Incorrect use of fabric softener
• Check fabric softener package
for instructions (see Fabric Softener
Dispenser section).
• To remove spots dampen the spots
and rub with undiluted liquid detergent.
Rewash, using chlorine bleach if it is safe
for the fabric.
Type of detergent
• Switch to a lower sudsing detergent brand
and fbllow instructions on package.
Very soft water
• Try less detergent.
Result of normal wear on
poly-cotton blends
• While this is not caused by the washer,
you can slow the pilling process by washing
poly-cotton blends inside out.
16