GE JBP26K Use And Care Manual page 22

C re and Cl nln
(See Cleaning Guide, pages 24 and 25)
_v_* _ _14_ _la_as b _
important so your range will give
you efficient and satisfactory
service. Follow these directions
carefully in caring for your range to
Cooktop
The porcelain enamel cooktop is
sturdy but breakable if misused.
This finish is acid-resistant.
However, any acid foods spilled
(such as fruit juices, tomato or
vinegar) should not be permitted
to remain on the finish.
Cleaning Under the Range
The area nncler the range
of models
equipped with a bottom drawer can
be reached easily for cleaning by
removing the bottom drawer. To
remove, pull drawer out all the way,
U.IL 1_1_ t/l_ J..tulll. _llK.It JL_,,a.,_llV_.JY_*,* ' Jt_. l't,J
renl:ae.e in_ext ¢,lides at back of
drawer beyond stop on range glides.
Lift drawer if necessary to insert
easily. Let front of drawer down,
then push in to close.
Removable Oven Door
1\\ _\ -._l
.to KV_,JVILJV12,(1oo/'_ opeI1 to DK_._JL,
position, or where you feel hinge
catch slightly. Grasp door at sides;
lift door up and away from hinges.
To REPLACE_ grasp door at sides.
Line up door with hinges and push
door firmly into place.
Your range is vented through a duct
located under the right rear surface
unit. Clean the duct often.
_n Ie_,ii.I¢.i/_¢t/_ •
,, Make sure unit is cool.
L,1It up rlgn[ rear suriace unit,
Remove trim ring and drip pan.
Lift out oven vent duct.
To replace:
• Dlnt,_ th_ hart ov_r the oven vent
located below the cooktop with
opening of the duct under the round
opening inth e drippan: I! is
important tnat me auct _s m me
correct position so moisture and
van_r_ from the r'_ver|¢_an be
released during oven use. NOTE:
Never cover the hole in the oven
vent duct with aluminum foil or
any other material. This prevents
I.llli_ ¢JV_71I VgTllt IIUIII _¢UiI_llI_
properly during any cooking cycle.
Lamp Replacement
CAUTION: Before replacing
your oven _amp bulb, disconnect
the electricpowerforyourrange
at the main fuse or circuit
breakerpanel. Be sure to let the
lamp cover and bulb cool
completely beforeremoving
or
1 I_[J li;[l._ll I_ tIl¢[ll.
'T'h_ r_zr, n larnn
fh]dh'_ i_ _nvered
with a glass removable cover which
is held in place with a bail-shaped
wire. Remove oven door, if desired,
to reach cover easily.
To remove:
t l.h_lA hand .rider r,_w_r _n it
doesn't fall when released. With
fingersOf same hand, firmly push
back wire bail until it clears cover.
Lift off cover. DO NOT REMOVE
ANY SCREWS.
Replace bulb with 40-watt home
appliance bulb.
To replace cover:
• Place it into groove of lamp
receptacle_ Pull wire bail forward
to center of cover unti! it snaps into
place. When in place, wire holds
cover firmly. Be certain wire bali is
in depression in center of cover.
Connect electric power to range.
Surface Units
Cl_:an the :area nnder
the drio
hans
often. Built-up soil, especially
grease, may catch fire. To make
cleaning easier, tilt-lock units lift
up and lock in the up position, and
plug-in units are removable.
Caution: Be sure all controis are
turned to t_ 1_anu surlace um
are cool before attempting
_.ohft
or remove them.
After lifting the tilt-lock units or
removin¢ nhm-in units, remove the
trim rings and drip pans under the
units and clean them according to
directions in the Cleaning Guide o.
pages 24 and ............
z3. w_pe arounu the
Clean the area below the units.
Rinse all washed areas with a damp
cloth or sponge.
A,g,,