GE DJSR473ET Use And Care Manual page 13

REVERSIBLE DOOR INSTRUCTIONS
(on models so equipped)
These instructions are for changing the hinges from
the right side to the left side.
If you need to change the hinges from the left: side to
the right side, follow these same instructions (merely
reverse all references to the left and right).
'Fools Needed
Standard #2 Phillips screwdriver
Tape-tipped putty knife
Needle-nosed
pliers
Dryer Door
1. Open the door and remove the filler plugs from
the side of the opening without hinges. Use a tape-
tipped putty knife to pry plugs loose and then gently
remove plugs with a pair of needle-nosed pliers.
2. With the door
completely open,
remove the bottom
screw from each hinge
on the dryer face.
3. Insert these screws
about half way into
the top holes, for
each hinge, on the
opposite side (where
/
filler plugs were removed). Apply
firm pressure to get screw started in
untapped holes.
4. Loosen the top screw from
each hinge on the dryer face
half way.
5. With one hand holding the top
of the door and the other hand
holding the bottom, remove the
door from the dryer by lifting it up and out.
.
Rotate the door 180 °. Insert it
on the opposite side of the _.'-.,
opening by moving the door /
in and down until the top
/
hinge and the bottom hinge J_
are resting on the top screws \
inserted in step 3.
o
go
9.
Remove the remaining
screws from the side of
the opening from which
the door was removed.
With these screws,
secure each hinge at
the bottom.
Tighten the two top
screws of each hinge.
Reinsert the plastic plugs on
the side from which the door was removed.
13