Download Print this page

GE GSHF5PGXAEWW Owner's Manual And Installation page 26

Advertisement

Available languages

Available languages

Installation
Instructions
INSTALLING THE WATER LINE
(CONT.)
[]
FASTEN THE SHUTOFF VALVE
Fasten the shutoff valve to the cold water pipe
with the pipe clamp.
Saddle-Tgpe
Shutoff Valve
Water Pipe
NOTE: Commonwealth
of Massachusetts
Plumbing Codes 248CMR shall be adhered to.
Saddle valves are illegal and use is not permitted
in Massachusetts.
Consult with gour licensed
plumbeE
[]
TIGHTEN THE PIPE CLAMP
Tighten the clamp screws until the sealing
washer begins to swell.
NOTE: Do not overtighten
or you may crush
the tubing.
Pipe Clamp
X4'
Clamp
Screw
Washer
r
Inlet End
[]
ROUTE THE TUBING
Route the tubing between the cold water line
and the refrigerator.
Route the tubing through
a hole drilled in the
wall or floor (behind the refrigerator
or adjacent
base cabinet) as close to the wall as possible.
NOTE: Be sure there is sufficient
extra tubing to
allow the refrigerator
to move out from the wall
after installation.
[]
CONNECT THE TUBING TO THE VALVE
Place the compression
nut and ferrule (sleeve)
for copper tubing onto the end of the tubing and
connect
it to the shutoff valve.
Make sure the tubing is fullg inserted into
the valve. Tighten the compression
nut securelg.
For plastic tubing from a GE SmartConnecf
M
Refrigerator
Tubing kit, insert the molded end
of the tubing
into the shutoff valve and tighten
compression
nut until it is hand tight, then
tighten one additional
turn with a wrench.
Overtightening
mag cause leaks.
Saddle-Tgpe
Compression Nut
Shutoff Valve
SmartConnecf"
Packing Nut
Ferrule (sleeve)
Outlet Valve
NOTE: Commonwealth
of Massachusetts
Plumbing Codes 248CMR shall be adhered to.
Saddle valves are illegal and use is not permitted
in Massachusetts.
Consult with gour licensed
plumber.
[]
FLUSH OUT THE TUBING
Turn the main water supplg on and flush out
the tubing until the water is clear.
Shut the water off at the water valve after about
one quart (1 liter) of water has been flushed
through
the tubing.
I To complete the installation of the refrigerator, go back
I
to Step 1 in Instolling the Refrigeroto_
I
26

Advertisement

loading