Table of Contents
Advertisement
5
MECHANICAL INTERFACE
For the purpose of installation and handling the camera in
an application two mechanical preparations have been
made to the camera body:
• Three M4 screw holes in the bottom of the camera
The one in the camera front end is the most important
one because this comprises the sensor.
• The camera neck can be clipped onto a fixed ring
(50mm h7)
In both cases it is advisable to design a alignment pin into
your mechanical placeholder
Figure 5-1: Inca bottom view
Page 18
Figure 5-2: Inca 3d view
Figure 5-3: Inca front view
2005-12-12
Advertisement
Table of Contents
