COMPANION 172.21399 Operator's Manual page 18

MOUNTnNG BAND SAW TO WORK STAND ( Fig. 5 )
Z_WARNING: ALWAYS make sure your band saw is securely mounted to a workbench or an
approved workstand. Motor vibration, weight on the worktable and other factors may cause the
band saw to tip over, slide or 'walk' along the workstand surface during operation. Failure to do so
could result in an accident, resulting in possible serious personal injury.
1. If the band saw is to be mounted in a permanent location, it MUST be secured to a supporting
surface such as a work bench.
2. The band saw must be securely fastened by the four
base holes to a workstand or workbench with
heavy-duty fasteners (not included). This prevents
the band saw from tipping over, sliding or
walking/creeping along the workstand or workbench
surface during operation. See diagram for proper
installation.
(Mounting hardware indicated is not included.)
1. Band saw base
2. Hex head bolt
3. Lock washer
4. Flat Washer
5. Workbench surface
6. Flat washer
7. Lock washer
8. Hex nut
nMPORTANT. If the workstand or workbench has a tendency to move during operation, fasten it
securely to the floor.
NOT5: Mounting hardware listed above is not included with the tool.
18