GE Profile TPX21PRXDBB Owner's Manual page 27

Route the Copper Tubingand Connect It to the Shutoff Valve
Route the copper tubing bel_en the cold water line and the refligeralor.
Roule the lubing lhrough a hole drilled in lhe wall
or floor
(behind the
refligeralor
or adjacenl base
€abinel}
as €lose 1o lhe
wall
as
possible.
Besurethereis sufficient e xtratubing/about 8 feet(244cm)coiledinto3 turnsof about
10"(25cm)diameter] t o allowthe
f_ff_t]eratof to move
outff_m the wailafter installation,
Place the compression nut and fenule (sleeve) onto the end of the tubing and
connect it lo the shutoffvalve.
Make sure the tubing is fully inserted inlo the valve. Tighlen the compression
nul securely.
Saddle-Type ShutoffValve _ Compressiorl Nut
Nut C2ut,et|Va_, e Ferrule(sleeve)
Turn On the Water and Flush Out the Tubing
the main water supply on and flush out the tubing m_fil the water
is clear.
_Shut the water off at the water valve atler aboul one quart ( 1 L) of water has
{{" { {'_ been flushed through the robing.
27