GE AGW10 Owner's Manual And Installation Instructions page 5

Lights next to the touch pads on the air conditioner
control panel indicate the selected settings.
_e.com
Cool Mode
Use the Coolmode with HIGH(F3), MED (F2) or
LOW(F1) fan for cooling. Use the INCREASER=/
DECREASE • pads to set the desired tempemune
between 60°F and 86°F in 1 °F increments.
An electronic fllemlostat is used to maintain file
room temperature. The compressor will cycle on and
off to keep file room at file set level of comfort. Set
file themlostat at a lower number and file indoor air
will become cooleL Set file flleI_nostat at a higher
number and file indoor air will become wamleL
NOTE: If the air conditioner is off and is then turned on
while set to a Coolsetting or if turnedfrom a fansetting
to a Coolsetting, # will take appreximately3 minutes for
the compressor to start and cooling to begin.
CoolingDescriptions
For Normal Cooling--Select file Cool mode and
HIGH(F3)or MED(F2)fan wifll a middle set
temperature.
ForMaximumCooling--Select file Coolmode
and HIGH(F3)fan with a lower
set temperature.
For Quieter & Nighttime Cooling--Select
file
Cool mode and LOW (F1)fan with a middle
set
temperature.
NOTE: If youswitch from a Coolsetting to OFFor to
a fan setting, wait at least 3 minutesbefore switching
back to a Coolsetting.
Fan Speed Mode
Use the fan at HIGH(F3),MED (F2)or LOW(F1)to
provide air circulation and filtering without cooling.
Since fan only settings do not provide cooling,
a mmperamre setting will not be displayed.
Vent Control
The vent control is located beside the control
panel.
X_qmn set at CLOSE, only the air inside the room
will be circulamd and conditioned. When set at
OPEN, some inside air is exhausted outside.
Toopen the vent, pull the lever toward you.
To close it, push it in.
Air Direction--Side-to-Side
The side-to-side air direction is adjusted by moving
the lever to the left or right.
Air Direction--Up and Down
Fingertip pressure on the horizontal louvers
adjusts the air direction up or down.
5