GE AGW10 Owner's Manual And Installation Instructions page 11

Window Installation Instructions
[] INSTALL THE CASE IN THE
WINDOW
[_] Open the window and mark the centerline
of the window stool.
[_] Carefully place the case on the window
stool and align the center mark on the
bottom front with the centerline of the stool.
[] Pull the window down behind the top
mounting rail.
NOTE: Do not shut the window so tightly that
movement of the accordion panels is
restricted.
[_] Loosely assemble the sill supports.
INDOOR OUTDOOR
Sillsupport
Select the position that will place the sill
supports near the outermost point on the
sill. Attach the sill supports to the case track
hole in relation to the selected position
using 2 type A screws in each support.
Frameguide
[] INSTALL THE CASE IN THE
WINDOW (CONT.)
[_] Adjust the bolt and the nut in each support
so that the case is installed with a slight tilt
to the outside. Use a level; about 1/3 bubble
will be the correct case slant to the outside.
i
FG--]Secure the case to the window stool by
using 3 type B screws.
Pull the accordion panels to each window
sash track. Attach them on each side to the
window sash and the window stool using
4 type C screws.
11