Reversing Valve Jumper Settings - Venstar T2800 Owner's Manual

Viewing the Heat Pump and

Reversing Valve Jumper Settings

Steps 15 and 16 are 'Read Only' and may only be set with the
jumpers on the circuit board of the thermostat.
Press the MODE button. While holding
MODE
the MODE, press the PROGRAM
button to enter Setup screens.
PROGRAM
Press the MODE button repeatedly
MODE
until this setup screen appears.
ON = Heat Pump
operation
OFF = Gas Electric
operation
Indicates that the
thermostat jumper
is set for an O
reversing valve
(energize in cooling)
or a b reversing valve
(energize in heating).
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
Note: Press the
button momentarily
to move through the
setup screens. Press
and hold the
button to move back-
wards through the
setup screens.
I5
Setup
OFF
I6
O Setup
Page 12.2
MODE
MODE
12
Press
MODE
Press
PROGRAM