Antenna Cable Connection - Sylvania ZV450SL8 Owner's Manual

ANTENNA CABLE CONNECTION

This section describes how to connect your unit to an antenna, cable box, etc.
1
Disconnect the power cord of your TV from the AC outlet.
2
Disconnect RF coaxial cable from antenna input jack of your TV.
disconnect
3
Connect cables to the unit.
Make the basic connection as illustrated below.
DVD/VCR
S-VIDEO IN --- AUDIO --- OUT
L
R
IN
IN --- VIDEO --- OUT
RCA audio RCA video
cable cable
R L
AUDIO IN VIDEO IN
4
Plug in the power cord of this unit and your TV to the AC outlet.
connect
Note
• For your safety and to avoid damage to the device, please unplug the RF coaxial cable from the ANTENNA IN jack
before moving the unit.
• If you use an antenna to receive analog TV, it should also work for DTV reception. Outdoor or attic antennas will be
more effective than set-top versions.
• RF output is for tuner pass through only. DVD playback through the RF is not possible.
E9H10UD.indd 15 E9H10UD.indd 15
rear of your TV
1 1 1
2
disconnect
rear of this unit
DVD
DIGITAL AUDIO S-VIDEO COMPONENT S-VIDEO IN --- AUDIO --- OUT
VIDEO OUT
AUDIO OUT OUT
Y
P
B
L OUT IN
/C B
IN --- VIDEO --- OUT
P
R
/C
R
rear of your TV
rear of your TV
rear of this unit
DIGITAL
AUDIO OUT
COAXIAL
RF coaxial cable
ANT. IN
OUT
DVD/VCR
L L
IN
ANTENNA
R R
OUT
IN
ANTENNA
RF coaxial cable RF coaxial cable
This connection is for
TV loop through only
ANT. IN
Supplied cables used in this connection are as follows:
• RF coaxial cable x 1
• RCA audio cable (L/R) x 1
• RCA video cable x 1
Please purchase the rest of the necessary cables at your
local store.
* Once connections are completed, turn on the TV and
initial setting begin.
Channel scanning is necessary for the unit to memorize
all available channels in your area.
(Refer to "INITIAL SETTING" on page 24.)
VHF / UHF
antenna
or
cable TV
company
VHF / UHF
antenna
or
cable TV
company
EN 15
2007/02/19 14:55:14 2007/02/19 14:55:14