Troubleshooting; Error Messages - Lenovo ThinkPad X30 Troubleshooting Manual

Troubleshooting

If you do not find your problem here, refer to Access ThinkPad, your
on-board help system. Open Access ThinkPad by pressing the ThinkPad
button. The following section only describes problems that might prevent you
from accessing this help system.

Error messages

Notes:
1. In the charts, x can be any character.
2. The version of PC-Doctor referred to here is PC-Doctor for Windows.
Message
0175: Bad CRC1, stop
POST task
0176: System Security -
The System has been
tampered with.
0187: EAIA data access
error
0188: Invalid RFID
serialization information
area or bad CRC2.
0189: Invalid RFID
configuration
information area
0190: Critical low-battery
error
0191: System Security -
Invalid remote change
requested.
0192: System Security -
IBM Embedded Security
hardware tamper
detected.
0197: Invalid Remote
change requested
0199: System Security -
IBM Security password
retry count exceeded.
Solution
The EEPROM checksum is not correct (block #6). Have the computer
serviced.
This message is displayed if you remove the Security Chip and reinstall it,
or install a new one. To clear the error, enter the BIOS Setup Utility. If this
does not solve the problem, have the computer serviced.
The access to EEPROM is failed. Have the computer serviced.
The EEPROM checksum is not correct (block # 0 and 1, or block # 6). The
system board should be replaced, and the box serial number needs to be
reinstalled. Have the computer serviced.
The EEPROM checksum is not correct (block # 4 and 5). The system board
should be replaced, and the UUID needs to be reinstalled. Have the
computer serviced.
The computer turned off because the battery is low. Connect the ac adapter
to the computer and charge the battery, or replace the battery with a fully
charged one.
The system configuration change has failed. Confirm the operation and try
again.To clear the error, enter the BIOS Setup Utility.
The Security Chip has been replaced with a different one. Have the
computer serviced.
The remote configuration for the Security Chip has failed. Confirm the
operation and try again.
This message is displayed if you enter a wrong supervisor password more
than three times. Confirm the supervisor password and try again. To clear
the error, enter the BIOS Setup Utility.
Solving computer problems
Chapter 2. Solving computer problems
11