Table of Contents
Advertisement
Before installing your TV please read the following important notes:
If you intend placing this TV into a cabinet or a wall alcove, please ensure there is at least a 100mm
(10cm) gap to the sides, rear and top of the Television. This is to allow for adequate ventilation
during TV operation.
Don't allow soft furnishings such as curtains to be draped over the TV whilst in operation.
Never place the TV on to a carpet during normal operation - this could obstruct ventilation slots on the base
of the TV. Always place the TV on a flat surface , or if supplied, the stand accessory.
Failure to observe the above guidelines could result in serious overheating of your TV, or even, in extreme
cases, fire.
TV ONLY INSTALLATION.
Aerial (RF) Lead
INSTALLATION VIA A VCR.
(RF) connector lead VCR to TV
Aerial (RF) Lead
*A scart lead should be fitted between your TV and VCR to enhance your picture and sound quality. Scart
leads are essential if you have a stereo TV and VCR and wish to obtain stereo sound from your equipment. These
leads can be purchased from your Hitachi dealer or any good 'High Street' electrical retailer.
Aerial (RF) Socket
wall socket
Aerial (RF) Socket TV
OUT
wall socket
Aerial (RF) Socket VCR
5
5
TV Installation
TV Installation
*Optional Scart Lead TV
to VCR
Advertisement
Table of Contents
