Attaching Lens Cap; Attaching Ferrite Cores - Hitachi DZMV270E Instruction Manual

Attaching Lens Cap

Pass the provided string through the hole in the lens cap and attach it to the hand strap of DVD video
camera/recorder.
1
Use the string to attach the cap to the DVD video
camera/recorder.
2
Push the both sides of cap inward and attach it
over the lens.

Attaching Ferrite Cores

Although the cores are not attached in the illustrations of the cables in text, be sure to attach the
ferrite core (provided) to the S-VIDEO cable using the following procedure (the ferrite core was at-
tached to the AV output cable at the factory):
(Ferrite cores reduce radio interference with your radio and TV.)
1
Open the cover of ferrite core.
2
Attach the core to the S-VIDEO cable at a posi-
tion approximately 5 cm from its end.
3
Close the cover of core, taking care that it does
not catch the S-VIDEO cable.
28
Note: Always keep the lens cap on when not us-
ing the DVD video camera/recorder, to protect
the lens.
Note: When recording, attach the lens cap to the
hand strap by hooking the tab inside the cap onto
strap for comfortable shooting.
Note: If you use an external microphone when
recording, attach the ferrite core (provided) to the
cable at a position approximately 5 cm from its
end: Wind the microphone cable round the core
once in the same way as for the S-VIDEO cable.
Using external microphone in modes other than
camera recording is not recommended.
5 cm