Table of Contents
Advertisement
The Remote Control
Using the remote control for normal TV functions
1. Insert two AAA batteries, making sure that the polarity is correct as marked
inside the compartment.
2. Aim the remote control at the IR sensor just below the green light (see
page 5 for diagram). Keep this area clear at all times.
3. Do not press the buttons on the remote too quickly – allow the TV time to
respond.
Press to enter or exit the standby mode
01. POWER
:
Press to turn on or off speaker output
02. MUTE
:
03. DISPLAY:
Press to show or remove status display
04. VOL+:
Press to increase volume
05. VOL-:
Press to decrease volume
06. Numbers:
Press to select a channel
07. AV/TV:
Press to select input source
08. PMODE:
Press to select picture display mode.
09. ENTER:
Press to confirm your selection
10. Directions:
Press
menu screens.
11. LCD Menu
Press to display the LCD Menu system (see p.9)
12. STOP
Press to stop play in DVD mode
13. PLAY/PAUSE
Press to start or pause play in DVD mode
14. ANGLE
In DVD mode, press to select viewing angles.
14.
In DVD mode press to skip to the next chapter.
SUBTITLE
Press to activate subtitles for Digital TV programs
where available.
16. A/E
Press in TV mode to make the current channel a
Favourite
OSD
In DVD mode press to display video details
17. FAV:
Press to enter the Favourites menu directly
SLOW
In DVD mode press to toggle slow motion speeds
18. TIMER:
Press to display the time
19. SLEEP:
Press to enter Sleep mode, where the TV will
automatically enter standby mode after a period of
time (toggle between "Off" and between 15 minutes
and up to 240 minutes)
6
to Select up, down, left, and right in
Advertisement
Table of Contents
