Advertisement
Quick Links
2 Speed Cordless Sweeper
Model: V2022
6 Volt DC
To Maximize the life of your NiCd batteries:
1. Charge for a minimum of 20 hours before initial use.
Failure to do so will reduce the product's battery life
significantly.
2. Do not store unit with the charging adapter attached
and plugged in.
3. Only recharge when the batteries are fully discharged
(or as close to fully discharged as possible).
4. Do not store in areas of high temperature or humidity.
5. After 3 months of non-use, the product should be fully
discharged and then recharged to maximize battery
power.
6. Use only the charger supplied with the product. If other
chargers are used, the batteries can fail causing damage to
the battery, product, or personal property.
NiCd batteries have a long useful life but at some time they
will need to be replaced. To purchase replacement batteries,
visit www.sharkvac.com
Note: 1. The On/Off switch must be in the "Off" position in
order to charge the unit. If the charging indicator
does not light, depress the On/Off switch once.
2. If the product has never been used or has been
stored for an extended period of time without use – it
will take several complete charge and discharge
cycles to realize the full operational time of your
product.
EURO-PRO Operating LLC
Boston, MA 02465
Tel. : 1 (800) 798-7398
www.sharkvac.com
Copyright © EURO-PRO OPERATING LLC 2008
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Euro-Pro Shark V2022
Summary of Contents for Euro-Pro Shark V2022
- Page 1 – it will take several complete charge and discharge cycles to realize the full operational time of your product. EURO-PRO Operating LLC Boston, MA 02465 Tel. : 1 (800) 798-7398 www.sharkvac.com Copyright © EURO-PRO OPERATING LLC 2008...
-
Page 3: Important Safeguards
The liability of EURO-PRO Operating LLC is limited solely to the cost of the repair or replacement of the unit at our option. This warranty does not cover normal wear of parts and does not apply to any unit that has been tampered with or used for commercial purposes. -
Page 4: Troubleshooting
PARTS AND COMPONENTS Handle Telescopic Tube Dust Cup Empty Button Lower Handle Extension Tube Steering Pivot Charging Light Indicator On/Off Switch Charging Jack Charging Adapter: Only Use Ktec model KA12D090015023U 10. Transparent Brush Cover 11. Rotating Brush 12. Edging Tool 13. - Page 5 OPERATING INSTRUCTIONS Slip the belt over the brush bar cap. Insert the brush bar into the slot. (Fig. 14) 10. Insert the gear box tabs into the tab slots and push down until it clicks into place. 11. To replace the squeegee, follow instructions above for removing the gear box and slide the squeegee out from left to right.
- Page 6 OPERATING INSTRUCTIONS 4. The telescopic tube is designed to adjust to the height that is comfortable for all users. To adjust the height, simply push down the release button on the telescopic tube and pull the handle to adjust to a comfortable height for using. (Fig. 2) Fig.
- Page 7 OPERATING INSTRUCTIONS Cleaning the Dust Cup Container To achieve the best performance, empty the dust cup container after each use. Press the dust cup release lever with your foot. (Fig. 9) Note : Be careful not to accidentally turn the unit “On” Fig.
- Page 8 OPERATING INSTRUCTIONS Removal of Battery Pack Press the dust cup release lever with your foot and remove it from the sweeper power head. Turn unit over so that the base is facing upwards. Be careful not to turn the unit Push in locking tab and lift off battery compartment cover.
Need help?
Do you have a question about the Shark V2022 and is the answer not in the manual?
Questions and answers