Euro-Pro Shark Cordless V1917CR N Manual
Euro-Pro Shark Cordless V1917CR N Manual

Euro-Pro Shark Cordless V1917CR N Manual

Cordless sweeper 7.2 volt dc – 7.2 volts cc

Advertisement

Quick Links

Cordless Sweeper
V1917CR N
7.2 Volt DC – 7.2 Volts CC
To Maximize the life of your NiCd batteries:
1. Charge for a minimum of 20 hours before initial use.
Failure to do so will reduce the product's battery life
significantly.
2. Do not store unit with the charging adapter attached
and plugged in.
3. Only recharge when the batteries are fully discharged
(or as close to fully discharged as possible).
4. Do not store in areas of high temperature or humidity.
5. After 3 months of non-use, the product should be fully
discharged and then recharged to maximize battery
power.
6. Use only the charger supplied with the product. If other
chargers are used, the batteries can fail causing damage to
the battery, product, or personal property.
NiCd batteries have a long useful life but at some time they
will need to be replaced. To purchase replacement batteries,
visit www.sharkvac.com
Note: 1. The On/Off switch must be in the "Off" position in
order to charge the unit. If the charging indicator
does not light, depress the On/Off switch once.
2. If the product has never been used or has been
stored for an extended period of time without use – it
will take several complete charge and discharge
cycles to realize the full operational time of your
product.
Copyright © EURO-PRO OPERATING LLC 2007

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Shark Cordless V1917CR N and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Euro-Pro Shark Cordless V1917CR N

  • Page 1 2. If the product has never been used or has been stored for an extended period of time without use – it will take several complete charge and discharge cycles to realize the full operational time of your product. Copyright © EURO-PRO OPERATING LLC 2007...
  • Page 2: Important Safeguards

    IMPORTANT SAFEGUARDS When using an electrical appliance, basic safety precautions should always be observed, including the following READ ALL INSTRUCTIONS BEFORE USING YOUR CORDLESS SWEEPER. WARNING To reduce the risk of fire, electrical shock, or injury: Do not charge this unit outdoors. Do not use outdoors or on wet surfaces.
  • Page 3: Parts And Components

    PARTS AND COMPONENTS Handle Telescopic Tube Dust Cup Empty Button Lower Handle Extension Tube Steering Pivot Charging Light Indicator On/Off Switch Charging Adapter: Only Use Kuantech KA12D120015023U Charging Jack 10. Transparent Brush Cover 11. Rotating Brush 12. Edging Tool 13. Gear Box 14.
  • Page 4 OPERATING INSTRUCTIONS Assembling Your Cordless Sweeper Your cordless sweeper will require very little assembly. You should remove it from the carton and familiarize yourself with all the components listed per the exploded view drawing. (Pg. 2) This will help you in the assembly and operation of your cordless sweeper.
  • Page 5: Charging Instructions

    OPERATING INSTRUCTIONS Charging Instructions Connect the charger plug to the charging jack or hole on the side of the sweeper. Plug the charging adapter into the wall outlet. (120V., 60Hz.) Use only charger Kuantech KA12D120015023U. (Fig. 2) Charging Light Indicator Fig.
  • Page 6: Battery Removal & Disposal

    OPERATING INSTRUCTIONS To Maximize The Life Of Your Ni-Cd Batteries 1. Charge for a minimum of 20 hours before initial use. Failure to do so will reduce the product’s battery life significantly. 2. Do not store the unit with the charging adaptor attached and plugged in. 3.
  • Page 7 OPERATING INSTRUCTIONS Removal of Battery Pack Press the dust cup release pedal with your foot and remove it from the sweeper power head. Turn unit over so that the base is facing upwards. Be careful not to turn the unit Push in locking tab and lift off battery compartment cover.
  • Page 8 OPERATING INSTRUCTIONS How To Operate Your Cordless Sweeper Before using, please ensure that the cordless sweeper has been initially charged for 20 hours. Your cordless sweeper will only operate properly when the batteries are fully charged. Your sweeper will operate for varying lengths of time on a full charge. This will depend upon the type of surface being cleaned.
  • Page 9 OPERATING INSTRUCTIONS Cleaning The Dust Cup Container To achieve the best performance, empty the dust cup container after each use. Press the dust cup release pedal with your foot. (Fig. 9) Note : Be careful not to accidentally turn the unit “On” Fig.
  • Page 10 OPERATING INSTRUCTIONS Changing The Rotating Brush, Gear Box & Squeegee Remove the extension tube handle from the sweeper power head. Turn the sweeper power head upside down being careful not to accidentally turn the unit “On”. Remove the brush cover. Push in on the locking tab of the gear box and lift the gear box to remove.
  • Page 11: Changing The Belt

    OPERATING INSTRUCTIONS Slip the belt over the brush bar cap. Insert the brush bar into the slot. (Fig. 14) 10. Insert the gear box tabs into the tab slots and push down until it clicks into place. 11. To replace the squeegee, follow instructions above for removing the gear box and slide the squeegee out from left to right.
  • Page 12: Care And Maintenance

    OPERATING INSTRUCTIONS Care And Maintenance To improve the performance and life of your unit, we recommend you do the following: 1. Once a month clean the unit with a dry cloth, including the chamber which the dust container fits into. Remove any hair, fiber or other materials that may have built up in the chamber, and on the rotating brush.
  • Page 13: Troubleshooting

    TROUBLESHOOTING PROBLEM POSSIBLE REASON POSSIBLE SOLUTION Batteries discharged. Charge unit. No power in electrical Check fuse or breaker. Replace outlet supplying fuse/reset breaker. charging adapter. Call Customer Service at Unit needs servicing. 1 (800) 798-7398. SWEEPER WILL Battery misplaced. Ensure that the wire terminal NOT OPERATE Brush roll jammed.
  • Page 14: One (1) Year Limited Warranty

    The liability of EURO-PRO Operating LLC is limited solely to the cost of the repair or replacement of the unit at our option. This warranty does not cover normal wear of parts and does not apply to any unit that has been tampered with or used for commercial purposes.

Table of Contents