Wireless Setup - Panasonic BB-HGW700A Installation & Troubleshooting Manual

Installation/Troubleshooting
Problem
The Camera Portal or
Setup Page cannot be
accessed from the WAN
side.

Wireless Setup

Problem
After setting MAC
Address Filtering,
wireless connection
does not work.
Others
Problem
The POWER indicator is
blinking red.
30
• The network may be congested. Wait a while and try to connect
again.
• To access the setup page, it may be necessary to set the web
browser. (see page 122 of Operating Instructions on the CD-
ROM)
• JavaScript is used on the setup page. If JavaScript is disabled in
the web browser settings, enable it and then access the setup
page.
1 Select Internet Explorer Tools, then Internet Options... in
Internet Explorer, and click the Security tab.
2 Click Custom Level... in Security level for this zone.
3 Enable "Active scripting" in Settings.
• The Camera Portal section of Access Control in Security in
Advanced Setup is set to Restricted Access on this product. Set
it to None or Administrator Only.
• Access may be prohibited in Security on the setup page. See
Filtering Log in Log on the setup page and make it accessible.
• When connecting this product under another router, use a router
that is compatible with UPnP™. This product cannot be used
when connected using a router with an in-built modem without
the UPnP™ function. Set the CP function to Enable referring to
page 80 of Operating Instructions on the CD-ROM.
• Viewnetcam.com may not be registered. Register to
Viewnetcam.com using the Link for Viewnetcam.com Service.
• See the Panasonic Support Website (http://panasonic.co.jp/pcc/
products/en/netwkcam/) for more details about setup.
• The hardware is damaged. Remove the AC cord plug from the
outlet and re-insert it (see page 9). If the problem is not solved,
contact an authorized servicenter.
Cause and Remedy
Cause and Remedy
Cause and Remedy