Using The Lan Mac Eeprom Utility - Packard Bell EasyNote TM86 Series Service Manual

Using the LAN MAC EEPROM Utility

You can use the MAC.BAT utility to write the MAC.CFG file to the EEPROM under DOS mode.
1. Use a text editor (for example: Notepad) to open the MAC.CFG file. You can see the MAC.CFG contents
as below:
2. In DOS mode, run the MAC.BAT file to write MAC values to eeprom.
40
WriteData = '001122334455'
StartAddr=7A
WriteLeng=6
KeepByte=0
MAC value
MAC address
MAC value length
don't care
Chapter 2