Advertisement
CABLE GUIDE
OPERATOR
PRESENCE SEAT
SEAT
WIRE
CONNECTOR
SEAT STRAPS
FJGo IA
INSTALL
OPERATOR
PRESENCE
SEAT TO
TRACTOR
Your Mower is equipped with and Operator Presence
Seat to provide for your safety. The Operator Presence
Seat must be installed on the seat of the tow vehicle
and must be plugged in to the Wire Harness of the
Mower for proper operation of this unit.
NOTE: In order to sta4 the mower _
you must
have the Operator Presence Seatplugged
into the Wire
Harness of the Mower and the Mower Blade Clutch
Lover in the disengaged position.
In order to en a e the
Blades You must be seated on the Tow Vehicle
and on the Operator Presence Seat.
•
Place the Operator Presence Seat on the Tractor
Seat with the Wire toward the bottom and secure
with the seat strap. (See Fig. 1A)
o
Lift Tractor Seat and install a cable guide in the
middle of the Tractor rear fenders,
P_ace Operator Preseace Seat Wire into Cable
Guide with the connector toward the rear so as to
connect with the Seat Switch Plug of the Wire
Harness,
,,
Lower Tractor Seat
o
Connect Operator Presence Seat wire to the Seat
Switch Plug of the Wiring Harness.
SAFETY
SEAT
.......... \
\\
\\
WiRiNG
DIAGRAM
\
\
\
\
SWITCH
ENGINE
ON/OFF
_WITCH
(NORMALLY
OPEN I
SWITCH
/
BLACK
WIRE(E)_
FROM MODULE
TO
\\
ENGINE
GROUND
RED WIRE
\
FROM
ON/OFF
SWITCH
TO MAGNETO
GROUND
BLUE WIRE
FROM SAFETY
SEAT
TO LOWER
SPADE
OF SWITCH
BLACK
WiRE --/
FROM ON/OFF
SWITCH
TO ENGINE
GROUND
/
BLACKWIRE
(A)
FROM
MODULE
TO SWITCH
(UPPER
SPADE)
:ROM
MODULE
TO
(UPPER
SPADE)
(F) FROM
MODULE
TO MAGNETO
GROUND
MODULE
Advertisement
