Advertisement
TO REPLACE HEADLIGHT
BULB
o Raise hood.
o Pull bulb holder out of the hole in the
backside of the grill.
• Replace bulb in holder and push bulb
holder securely back into the hole in the
backside of the grill.
• Close hood.
INTERLOCKS
AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly, stop running, or pre-
vent it from starting.
° Check wiring. See electrical wiring dia-
gram in the Repair Parts section of this
manual.
TO REPLACE
FUSE
Replace with 30 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.
TO REMOVE HOOD AND GRILL
ASSEMBLY
o Raise hood.
° Unsnap headlight wire connector.
° Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
o To replace, reverse above procedures.
ENGINE
Maintenance,
repair, or replacement
of the
emission control devices and systems,
which are being done at the customers
expense, may be performed by any non-
road engine repair establishment
or indi-
vidual.
Warranty repairs must be per-
formed by an authorized engine manufac-
turer's service outlet.
TO ADJUST THROTTLE
CONTROL
CABLE
The throttle control has been preset at the
factory and adjustment should not be nec-
essary. Check adjustment
as described
below before loosening cable. If adjust-
ment is necessary, proceed as follows:
• With engine not running, move throttle
control lever from slow to choke posi-
tion. Slowly move lever from choke to
fast position.
° Check that holes "A" in governor control
lever and hole in governor plate line-up.
If holes "A" are not aligned, loosen
clamp screw and move throttle cable
until holes are aligned. Tighten clamp
screw securely.
Governor
Governor
Control Lever
Control Plate
Hood
Headlight
Wire
Connector
\
Holes "A"
Clamp
Screw
Throttle
Cable
25
Advertisement
