Craftsman 917.271052 Owner's Manual page 19

Every t00 hours of operation (more often
under extremely dusty, dirty conditions),
remove the blower housing and other
cooling shrouds. Clean the cooling fins
and external surfaces as necessary,
Make sure the cooling shrouds are
reinstalled.
NOTE: Operating the englne with a
blocked grass screen, dirty or plugged
cooling fins, arid/or cool!ng shrouds
removed will cause engrne damage due
to overheatfng.
AIR FILTER
Your engine will not run properly using a
dirty air filter. Glean the foam pre-
cleaner after every 25 hours of operation
or every season. Service paper car.-
tridge every t00 hours of operation or
every season, whichever occurs first,
Service air cleaner more often under
dusty conditions.
• Remove knob and cover.
o Remove wing nut and air cleaner from
base.
TO SERVICE PRE-CLEANER
• Slide foam pre-cleaner off cartridge.
° Waeh tt in Ifqutd detergent and water,
° Squeeze It dry In a clean cloth. Allow
it to dry.
o Saturate It in engine oil. Wrap it In
clean, absorbent cloth and squeeze to
remove excess olt.
TO SERVICE CARTRIDGE
o Replace a dirty, bent, or damaged
cartridge,
NOTE; Do not wash the l_aper cartridge
or use pressurized air, as this will
damage the cartridge.
• Reinstall the pre-cleaner (cleaned
and oiled) over the paper cartridge.
,, Reassemble air cleaner, wing nut,
cover and tighten knob securely.
ENGINE OIL FILTER
Replace the engine oil filter every
season or every other oil change tf the
tractor is used more than 10o hours in
one year,
. Drain oil from engine crankcase (See
"TO CHANGE ENGINE OIL" tn this
section of this manual, through step
remove drain plug),
° Remove oil filter and wipe off filter
adapter.
• Apply a tWn coating of new engine oil
to the rubber gasket on replaoement
oil filter°
,, Install replacement otl filter on filter
adapter. Turn oil filter clockwise until
rubber gasket contacts the filter
adapter, tt3en tighten filter an addi-
tional 1/2 turn.
° Fill crankcase with new oil (See "TO
CHANGE ENGINE OIL" In this section
of tfTls manual). For approximate
capacity see "PRODUCT SPECIFICA-
TIONS" section of this manual.
° Start the engine end 0hack for Oil
leaks, Correct any leaks before placing
engine into full operation.
19
MUFFLER
Inspect and replace corroded muffler
and spark arrester (if equipped) as It
could create a flre hazard and/or
damage.
SPARK PLUGS
Replace spark plugs at tile beginning of
each mowing season or after every 100
hours of operation, whicl]ever occurs
first° Spark plug type and gap setting are,
shown in "PRODUCT SPECIFICATIONS
section of this manual,
IN-LINE FUEL FILTER
The fuel filter should be replaced once
each season, If fuel filter becomes
clogged, obstructing fuel flow to carbure..
tor, replacement is required°
° With engine cool, remove filter and
plug fuel line sections,
• Place new fuel filter In position in fuel
line with arrow pointing towards
carburetor.
° Be sure there are no fuel line leaks
and clamps are properly positioned.
° immediately wipe up any spltled
gasoline.