Manual And Automatic Turn On-Off Options - Parasound HALO JC Owner's Manual

MANUAL AND AUTOMATIC TURN ON-OFF OPTIONS

5
The JC 1 can be turned on and off manually or automatically for your convenience.
Using the Front Panel On-Off Button
For manual operation, the JC 1 rear panel
Connecting an Active Audio Source for Automatic Turn On-Off
The JC 1 can be turned on and off with an audio
how long the JC 1 delays its actual turn on after it's been triggered.
Audio for Automatic Turn On-Off
To automatically turn on the JC 1 whenever music is playing (an audio signal is present), select the Audio trigger
by moving the AutoTurn On
in Technically Speaking
What You'll need:
An active audio source connected to the
Before Connecting
To Connect
YOU SHOULD KNOW
Turn Off Delay in the Audio Mode
When the music (audio signal) stops, the JC 1 will remain turned on for about five minutes.This
delay prevents unwanted turn-off during silent passages in music or pauses between tracks.
AutoTurn On
switch right to its Audio Signal
for more information about adjusting the level of audio required to turn the JC 1.
Remove power to all the components in your audio system.
Make sure the AutoTurn On
Set the Audio triggering
Start with the 3 o'clock detent (click stop) position.
Connect an active audio source to either the
to pages 2 and 3)
Auto Turn On
None 4
Delay
Seconds
12 8
20 50
Sensitivity
Input mV
200 100
< <
Select
12 Volt Audio
Trigger Signal
Manual
12V Input
Trigger
Output
switch must be in its
signal, or by an external trigger voltage. You can also adjust
position. Refer to AudioTrigger Sensitivity Adjustment
Balanced or Unbalanced Input
switch on the JC 1 is in its
Sensitivity adjustment knob on the rear panel to the desired level.
Balanced
Start Sensitivity at 3 o'clock
Switch in right Audio Signal position
Manual (middle) position.
jack on the JC 1
Audio Signal (right) position.
or Unbalanced Input jack. (Refer