Control Panel And Settings; Display Lights - GE PDWT200VWW Owner's Manual

About the dishwasher control panel.
Youcanlocate your model n umberonthetubwal!justinsidethedoor.Throughout thismanualfeatures andappearance m ay varyfromyourmodel.
Front-Control Dishwashers
_ _..
Sensing © _
Sanitized O _ _ © Clean
Cycles
.............................................. Options
Light ......... 0 _.s--- .............. ................ 0
(_ash) /N_ f" San, _ F_ //Start Del_y_°_ Seeeted_, f_Added_ (S;iam)
.............................. _ ...... / k Wash_ / Auto , \\_ Hours // [Dry) [ Heat )
............................................ .............................
...... ..............................
N "N .......
Top-Control Dishwashers
AUTO PLASTICS
DEEPCLEAN CHINA SELECT
NORMAL RINSE CYCLE
QUICK TOP RACK I I
D
B
LOW DETERGENT
LOCK
SANITIZED
CLEAN TIME REMAINING
DELAY HRS STEAM
I 11 I I
/
START
HEATED DRY]_ ] ADDED HEAT RESET
I I I [
Control Settings
_ Status
Lights (Indicatorsvary by models)
Indicator
The Status display tells you what is happening while the dishwasher isin operation and may flash,indicating
o malfunction. The lights will come ON indicating the sequence of the dishwasher operation.
LOW DETERGENT
SENSING
SANITIZED
CLEAN
CYCLE STATUS
INDICATOR
Displayedwhen the SmartDispense
TM
needs to be refilled with liquid or gel automatic
dishwasher detergent.
NOTE:If you are not usingSmartDispense
TM
and you want to turn the LOW DETERGENT
LEDlight off, press the ADDED HEATbutton 5 times within 3 seconds.You will hear 3
beeps;then the light will go off.You can turn the light back on by pressingthe ADDED
HEATbutton 5 times within 3 seconds.
Displayedwhile the CleanSensor
TM
is measuring the amount of soil and temperature
of water. The dishwasher will adjust the selected cycleto achieve optimal performance.
Displayedat the end of the cyclewhen SANITIZE has been selected and the dishwasher
has met the requirements for sanitization.SeeSANITIZE, below,for complete cycle
description. Opening the door or pressing any key while the door is closed and latched
will turn off the light.
Displayedwhen a wash cycle is complete. Referto Item 6,page 9, for further
explanation of clean light operation
The cyclestatus indicator light is located on the right sideof the dishwasher,above the
handle.This light comes on as amber while the selected cycle is running.The light turns
to green when the selectedcycle iscomplete. The light stays ON as green as a reminder
that the dishes are clean until the door is opened or until another cycle is selected.
I I _'_Cycle Status Indicator Light
/
(
1
_ ime Remaining Displag (onsome models)
During operation, the display shows the minutes remaining until the cycle is complete. The display may
adjust the remaining time while the Sensing light is on. The time displayed at the start of each cycle may
change from the factory setting as the unit customizes itself to home use. During a delay start, the display
will show hours of time remaining until the cycle starts.
NOTE:This dishwasher is equipped with CleanSensor
TM
with automatic temperature control; therefore,
cycle length and time may vary depending on soil and water temperature conditions.