Craftsman 921.16472 Owner's Manual page 7

This product isequipped withacordhaving a grounding wire arenot c ompletely understood, orifindoubt astowhether the
withanappropriate grounding plug. The plug must b eplugged product isproperly grounded. Donotmodify theplug provided; if
intoanoutlet t hatisproperly installed and grounded in itwillnot f ittheoutlet, have theproper outlet i nstalled bya
accordance withalllocal c odes a ndordinance, licensed electrician.
__ Improper
installation of the
grounding plug can result in a risk of electric shock.
If repair or replacement of the cord or plug is
necessary, do not connect the grounding wire to
either fiat blade terminal of the plug. The wire"
insulation having an outer surface that is green with
or without yellow stripes is the grounding wire.
This product is for use on a 115 volt circuit. A cord with a
grounding plug, as shown here, shall be used.
Make sure that the product is connected to an outlet having
the same configuration as the plug (see Fig. 5). No adapter
should be used with this product.
Check with a licensed electrician if the grounding instructions
Grounding Pin
Fig. 5
Grounded
Outlet
DALLY START-UP
1. Turn the pressure switch to the OFF position (see C).
2. Close the tank petcock (see F). Turn in the clockwise
direction.
3. Plug in the power cord.
Fig. 6
,i_IL_ High temperatures are generated
by the electric motor and the pump. To prevent
burns or other injuries, DO NOT touch the
compressor while it is running. Allow it to cool
before handling or servicing. Keep children away
from the compressor at all times.
4. Turn the pressure switch to the AUTO position (see D).
5. Adjust the regulator to the working pressure of the tool,
OFF (C)
(D) AUTO
// G ,_
/ ,
/
NOTE: To adjust pressure setting, pull out the knob and turn
clockwise to increase pressure, and counterclockwise to
decrease pressure. To lock a pressure setting, push the knob in.
__When adjusting from a higher to a
lower pressure, turn the knob counterclockwise past
the desired setting, then turn clockwise to reach the
desired pressure. Do not exceed operating pressure
of the tool or accessory being used.
SHUTDOWN
1. Turn the pressure switch to the OFF position (see C).
2. Unplug the power cord.
3. Reduce pressure in the tank through the outlet hose. You
can also pull the tank safety valve ring (see G) and keep it
open to relieve pressure in the tank.
4. Open the petcock (see E) to allow moisture to drain from
the tank.
,__Escaping air and moisture can
propel debris that may cause eye injury. Wear safety
goggles when opening petcock.
/,
E OPEN
',,, CLOSE F
200-2798 7