Advertisement
ASSEMBLY
INSTRUCTIONS
Remove TRIMMER from carton and examine it thoroughly
to
make sure it is not damaged.
- Remove
and discard protective
plastic clips
inserted in
handle tubes before assembly of trimmer.
TOOLS NEEDED FOR ASSEMBLY
• Medium Phillips screwdriver
• Adjustable wrench or pliers
ATTACHING
THE TUBES
1. Slide outer tube sleeve up lower tube and over upper
tube until the assembly
holes are aligned,
being
careful
not
to
pinch
or
cut
harness
wire.
NOTE: Should the outer tube be difficult to slide, grasp
outer tube sleeve firmly
and twist slowly back and
forth"whiie puslling Upward.
....................
2. Insert screws, attach Iocknuts and tighten. (FIG. I)
ATTACHING THE GUARD
TURN
TRIMMER
UPSIDE
DOWN.
SLIDE. REAR GUARD
SECTION AND FRONT GUARD SECTION INTO GROOVES
ON TRIMMER
HOUSING (F1G.2).
INSERT 2 SCREWS SUPPLIED AND TIGHTEN FIRMLY.
DO NOT OPERATE TRIMMER WITHOUT GUARD IN PLACE.
-CAUTION:
THE
CUTTING
BLADE
MOUNTED
IN THE
GUARD
ASSEMBLY
IS EXTREMELY
SHARP AND CARE
SHOULD
BE
EXERCISED
WHEN
HANDLING
OR
OPERATING
TRIMMER
TO
AVOID
CONTACT
WiTH
CUTTER.
HANGER
POWER
_
LOR_ GUARD
_
TUBE
BLUE ASS'€. _
FRONT GUARD
currlNG
FIG.1
•
r
•
FIG. 2
FR_
GUARD
THE OPERATION OF ANY TRIMMER CAN RESULT IN FOREIGN OBJ ECTS BEI NG THROWN
INTO THE EYES, WHICH CAN RESULT IN SEVERE EYE DAMAGE
ALWAYS WEAR SAFETY
GLASSES OR EYE SHIELDS
BEFORE COMMENCING
POWER TOOL OPERATION. WE
RECOMMEND
WIDE VISION SAFETY
MASK FOR OVER SPECTACLES
OR STANDARD
SAFETY GLASSES AVAILABLE AT SEARS RETAIL OR CATALOG STORES.
Advertisement
