Vcr Setup; Setting The 3 Ch. 4 Switch; Remote Control - Optimus 110 Owner's Manual

16-547.fm Page 13 Tuesday, July 20, 1999 4:45 PM

VCR SETUP

SETTING THE 3 CH. 4 SWITCH

If you connected the VCR's
nal to a TV or another VCR, set the VCR's
switch (on the back of the VCR) to
3 CH. 4
, whichever is not an active channel in your
4
area.
When VCR appears on the display, the VCR
sends the signal from the video source con-
nected to its
IN FROM ANTENNA
(or for the Model 60) terminals
VIDEO 1 IN AV2
to the TV on the channel you selected.
Note: The switch has no effect on the
3 CH. 4
TV when the VCR is off or if you connected a
TV with separate audio/video input jacks to the
VCR's
AUDIO 1/VIDEO 1 OUT

REMOTE CONTROL

Installing the Batteries
The remote control requires two AA batteries
(not supplied). For the longest operation and
best performance, we recommend alkaline bat-
teries (such as RadioShack Cat. No. 23-557).
Cautions:
• Use only fresh batteries of the required
size and type.
• Never leave dead or weak batteries in the
remote control. Batteries can leak chemi-
cals that can damage your remote control.
• Dispose of dead batteries promptly and
properly; do not bury or burn them.
1. Press the tab on the battery compartment
termi-
OUT TO TV
or
3
2. Put fresh batteries in the compartment, as
or
AUDIO 1/
jacks.
3. Replace the cover.
Note: If the remote control does not work or
operates poorly, replace both batteries.
Using the Remote Control
To use the remote control, aim it at the front of
the VCR and press the desired function but-
tons.
cover and lift off the cover in the direction
of the arrow.
indicated by the polarity symbols (+ and –)
marked inside.
13