Advertisement
POSITIVE
0 ° BEVEL
STOP
See Figure 23.
ADJUSTMENT
SCREW
REVEL
ADJUSTMENT
KNOB
• Turn screw and adjust base untilsquare with saw
blade.
•
"nghten hax nut and bevel adjustmentknobsecurely.
"_
WARNING:
Attemptingto make cutswithout
bevel adjustment knob securely tightened con result
in sadous injury.
TO POCKET CUT
See Figure 24.
HEX NUT
POSITIVE 0°
BEVEL STOP
BLADE
WARNING:
Always adjust bevel setting to zero
before meldng a pocket cut. Attemptinga pocketcutat
any otharsettingcon resultin lossof contmlof your
saw possiblycausingseriousinjury.
CARPENTER'S
SQUARE
Adjust the bevel settingto zero, set blade to correctblade
depth setting, and swingthe lower blade guard up using
the lower blade guard handle.
Always raise the lower blade guard wRh the handle to
avoid serious Injury.
While holdinglowerblade guard by the handle,firmly rest
the frontof the base flat against the workpiecowith the
rear of the handle raised so the blade does not touchthe
workpiese. See Figure24.
Fig. 23
Your saw has a positive O° bevel stop,that has been
factory adjusted to assure 0 ° angle of your saw blade
when making 90° cuts. However, misalignmentcon occur
duringshipping.
TO CHECK
•
Remove battery pack from saw,
WARNING:
Failure to remove battery pack from
saw could result in accidental starting causing
possibleserious personal injury.
•
Place your saw in an upside down positionon
workbench. See Figure 23.
•
Using a carpenter'ssquare, check squareness of saw
blade to the base of your saw.
TO ADJUST
•
Remove battery pack from saw.
WARNING:
Failure to remove battery pack from
saw could result in accidental starting causing
possible serious personal injury.
•
Loosen bevel adjustment knob.
•
Loosen hex nut securingadjustment screw.
18
LOWER BLADE
GUARD HANDLE
POCKET CUT
LOWER BLADE GUARD
Fig. 24
Depress the lock-offbutton and squeeze the switch trigger
to start your saw. Always let the blade reach full speed
then slowly lower blade Into the workplace until base
is flat against workpisce.
Afteryou complete yourcut release the triggerand allowthe
bladeto come to a complete stop.Afterthe blade has
stopped,removeit fromtha workpieco.Comers maythen be
clearedoutwith a hand saw or sabre saw,
WARNING:
Never tie the lower blade guard in a
raised position. Leaving the blade exposed could
lead to serious injury,
Advertisement
