Craftsman EZ3 917.271121 Owner's Manual page 27

Connectthe other
end of the BLACK
cable to good CHASSIS GROUND,
away_from fuel tank and battery..
"O REMOVE CABLES, REVERSE
:)RDER -
Remove BLACK cable first from chassis
and then from the fully charged battery.
Remove RED cable last from both bat-
-teries.
Positive Terminal
Negative Terminal
Headlight
Wire
Connector
ed
Battery
Positive Terminat- Negative Terminal
TO REPLACE HEADLIGHT BULB
• Raise hood.
• Pull bulb holder out of the hole in the
backside of the grill.
• Replace bulb inholder and push bulb
holder securely back into the hole in the
backside of the grill.
• Close hood.
INTERLOCKS AND RELAYS
Loos e or damaged wiring may cause your
tractor to run poorly, stop running, or pre-
vent it from starting.
t- Check wiring. See electrical wiring dia-
gram in the Repair Parts section of this
manual, "-
_TO REPLACE FUSE
Replace with 30 amp.., a utomotive-type
plug-in fuse. The fuse-holder is located
behind the dash.
TO REMOVE HOOD AND GRILL AS-
SEMBLY
• Raise hood.
• Unsnap headlight wire connector.
• Stand in front of tractor. Grasp hood at
sid_sr-tJb-towa_d engine and lift off of
tractor;
• To ]_ac_.reverse above procedures.
ENGINE
Maintenance, repair, or replacement of the
emission control devices and systems,
which are being done at the customers
expense, may be performed by any non-
road engine repair establishment or indi-
vidual. Warranty repairs must be per-
form. e d by an authorized engine manufac-
turer's service outlet.
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at the
factory and adjustment should not be nec-
essary. Check adjustment as described
below before loosening cable. If adjust-
ment is necessary, proceed as follows:
• W'_hengine not running, move throttle
control lever from slow to choke posi-
tion. Slowly move lever from choke to
fast position.
• Check to see if hole in throttle lever and
hole in speed control bracket are
aligned.
• If holes are not aligned, loosen cable
clamp screw an..d.align the holes by
insertinga pencil or a 1/4" drill bit
through both holes.
• Pull throttle cable up to remove slack
and.tighten cable clamp screw. Remove
alignment pencil or drill bit.
Cable
Screw
Speed Control
Bracket
27
Throttfe-Eever