Advertisement
_
WARNING:
Your sander should
be
never
connected to power supply when you are
assembling
parts, making adjustments,
assembling
or replacing sandpaper, cleaning, or
when not in use. Disconnecting
sander will
prevent accidental starting that could cause
serious personal injury.
APPLICATIONS
(Use only for the purposes listed below.)
•
Sanding on wood surfaces.
•
Removing rust from and sanding steel surfaces.
•
Polishing and buffing.
INSTALLING
SANDPAPER
See Figure 7.
RUBBERPAD
ADHESIVE
3NG
PRESSURESENSITIVE
ADHESIVEBACKEDSANDPAPER
The rubber pad on your sander accepts pressure
sensitive adhesive backed sandpaper. Precut triangle
shaped sandpaper in assorted grits is available from
your local Sears Retail Store.
•
Unplug your sander.
,_
WARNING:
Failure to
sander could
unplug your
result in accidental starting causing possible
serious personal injury.
•
If installing sandpaper for the first time, simply
proceed as follows in steps 3 and 4. If replacing
sandpaper, first remove old sandpaper by peeling it
off rubber pad, and then proceed to the following
steps.
•
Carefully peel adhesive backing from new
sandpaper.
•
Position sandpaper into place, then carefully press
sticky side of sandpaper on rubber pad.
,_
WARNING:
Before connecting
sander to
your
power supply source, always check to be sure
switch is not in on position. Failure to do so could
result in accidental starting of your sander
resulting in possible serious injury.
EXTENSION
CORDS
The use of any extension cord will cause some loss of
power. To keep the loss to a minimum and to prevent tool
overheating, use an extension cord that is heavy enough
to carry the current the tool will draw.
A wire gage size (A.W.G.) of at least 16 is recommended
for an extension cord 100 feet or less in length. When
working outdoors, use an extension cord that is suitable
for outdoor use. The cord's jacket will be marked WA.
_
CAUTION:
extension cords
from
Keep
away
the sanding area and position the cord so that
it will not get caught on lumber, tools, etc., during
sanding.
Fig. 7
,_,
WARNING:
Check extension cords before each
use. If damaged replace immediately. Never use
tool with a damaged cord since touching the
damaged area could cause electrical shock
resulting in serious personal injury.
Extension cords suitable for use with your detail
sander are available at your nearest Sears Retail
Store.
9
Advertisement
