Interior Light - GE Monogram ZDBC240 Owner's Manual

Controls and Features
Br,verag'e ( entr, r
7>mpoature
conbvl
Tire operating temperatures of the
beverage center rang> flom tile low forties
to tile mid fifties.
Do not irrstal] tire beverage center where
tile temperature will go below 55°F (13°C)
or above 90°F (32°C).
As with arty refligeration product, there is
a slight temperature variance at dirt>rent
locations within tile cabinet.
Tile coolest area will be in tile lower part
of tire cabinet.
Tile cooler area will be in tile middle
section.
Tile upper part of tile cabinet is tile
warmest section.
When tire temperature is adjusted, allow
24 honrs fox tile unit to stabilize.
To set the control, turn it to tile midpoint
setting (approximately 45°F). Once tile
beverage center is loaded, allow at least
24 hours before making any adjustments
to tile initial setting.
OFF
COLDEST__ COOLI
Interior light
and switch
Tile irrterior light makes it easy to view
your beverage labels arrd enhances tile
display of vonr collection.
When tire switch is ira tile OFF position,
tile light comes on only when tile door
is opened. When tire switch is in tire ON
position, tire light remains on continuously
fox your maximuna viewing pleasure. Fox
best viewing, do not store a bottle on
tire top shelf directly under the light.
Remember to turn off tile light when
it is no longer needed.
Glass shelves
Tempered glass shelves in tile beverage
center unit are removable for easy
cleaning or for storing larger items.
To remove a shelf, open tire door
completely to avoid pomntial damage to
tire gasket. Lift up on tile back of tire shelf
slightly. Tilt tire shelf to one side at an
arrgle while pulling forward.
To replace a shelf, open tire door
completely to avoid potential damage
to tire gasket. Tilt the shelf m one side
at an angle arrd slide toward tile back wall,
placing one side onto tire shelf support.
Place tire other side onto tile opposite
shelf support. Ensure rear locking tabs
are engaged. When installed properly,
tire shelf will not slide forward when
gently pu]led.
To remove, lift up on the back of the shelf
Tiltthe shelf at an angle while removing
or replacing
Place in slots when replacing the shelf