Advertisement
SANDING (Continued)
Extended pedods of sendingas shown in Figure 5
may tend to overheat the motor. If this occurS,turn
sender off and wait until sandingdisc comas to a
complete stop,then remove it from workpiece.
Remove your hand from vent area and let motorcool.
DUSTLESS SANDING
The dust box located on the rear of your sender
providesa dust collectionsystem for your sander.
Sanding dust is drawn up throughthe holes of the
sandingdisc to collectin the dust box during sanding
operation. For more efficientoperation,empty dust box
when half full.
TO INSTALL DUST BOX
See Figure 8
•
Realign dust box with rear of sender.
•
Slide dust box on sender as shownin figure 8. You
will feel a softclick as the tab snaps into place.
Note: As mentionedabove, be careful not to break
the tabs that secure dust box to sander.
REMOVING
DUST BOX
See Figure 7.
•
To release dust box, depresstabs located on each
side of dust box.
• Slide dust box down and liftfrom sender as shown
by the arrows in figure 7,
•
Do not press on the filter matedal with your handor
fingers. Filler material can be damaged.
Note: Filter material is located on the sides of dust
box.
•
Do not break tabs that secure dust box to sander.
•
Empty dust box.
TABS
TOINSTALL
DUSTBOX
TABS
TOREMOVE
Fig, 7
REMOVE BANDING DISC BEFORE STORAGE
Do not store your sander with a sandingdisc installed.
Heat generated from sanding causes the pressure
sensitiveadhesive to flow and form a tight bond
between the backing pad and sending disc.
Removingthe sending disc soon after you have
finisheda sandingoperation avoids letting the
adhesive set up. If the sandingdisc is left on the
beckingpad for an extended period of time after use,
the adhesivewill set up end cause the sandingdisc to
become difficultto remove. It may also tear when
removing.When this situationoccurs, it becomes
difficultto clean the backing pad for the next sanding
disc,
Note: If you forget to remove the sending disc after a
sending operation, sand for a few minutesto soften
the adhesive backing before attemptingto remove
sending disc.
A
WARNING:
Do not use this productas a
componentof other products.Also, do not use
attachments or accessoriesnot recommended
for use with this product,Any such use could
result in possibleserious personal injury.
Advertisement
